BP2500E0805AT BAND PASS FILTER SPECIFICATION Rev. A PRODUCT FEATURES 1. Surface mount band pass filter with a small size of 2.0 X 1.2 X 0.6 mm, RoHS compliant. 2. Provide low insertion loss, high rejection rate, and low profile. 3. Highly stable under temperature and humidity changes. RF CHARACTERISTICS PHYSICAL DIMENSIONS P/N BP2500E0805AT Specification Symbol Dimension (mm) Frequency range 2400 - 2500 MHz Insertion Loss (max) 1.8 dB max L 2.00 ± 0.15 VSWR 2.0 max W 1.25 ± 0.15 50 Ω T 0.60 ± 0.10 A, E 0.20 ± 0.15 B, G 0.30 ± 0.15 15dB @ 4800-5000 MHz C 0.35 ± 0.15 15dB @ 7200-7500 MHz D 0.65 ± 0.15 F 0.475 ± 0.15 H 0.25 ± 0.15 Impedance 25dB @ 870-960 MHz 25dB @ 1710-1910 MHz Attenuation (min.) 20dB @ 1910-1990 MHz -40°C to +85°C Operating temperature range TERMINAL CONFIGURATION P1 P2 P3 P7 P6 P4 Definition PIN Definition P1 OUT P5 IN P2 NC P6 GND P3 NC P7 NC P4 GND P8 GND P5 Frontier Electronics Corp.® http://www.frontierusa.com PIN P8 Page 1 of 2 667 E. Cochran St., Simi Valley, CA 93065 Phone: 1-805-522-9998, Fax: 1-805-522-9989 BP2500E0805AT BAND PASS FILTER SPECIFICATION Rev. A PCB DESIGN/LAYOUT CONSIDERATION Figure Design trace width to be 50 Ohms impedance. Symbol Dimension (mm) L1 0.40 ± 0.05 L2 0.20 ± 0.05 L3 0.90 ± 0.05 L4 2.10 ± 0.05 L5 0.80 ± 0.05 L6 0.80 ± 0.10 L7 0.80 ± 0.05 D1 0.40 ± 0.05 D2 0.20 ± 0.05 D1 and D2 are via holes to ground. Typical RF Performance Frontier Electronics Corp.® http://www.frontierusa.com Page 2 of 2 667 E. Cochran St., Simi Valley, CA 93065 Phone: 1-805-522-9998, Fax: 1-805-522-9989