RoHS SMD SEMI SHIELDED POWER CHIP INDUCTOR Dimensions: .119±.008 (3.0±0.20) .041 MAX (1.02) .04 (1.0) XXX .119±.008 (3.0±0.20) Inches (mm) .087 (2.2) Magnetic Resin .04 (1.0) .04 (1.0) .04 (1.0) Recommended Pattern Inductance Tolerance (µh) (%) Allied Part Number Test Freq. MHz, 200mV RDC (mΩ) ±30% Isat (A) (Max) Irms (A) (Max) Marking 1530 1R5 2R2 4R7 6R8 PCFV30-1R5M-RC 1.5 20 1 .085 PCFV30-2R2M-RC PCFV30-4R7M-RC 2.2 4.7 20 20 1 1 .100 .205 1620 1350 900 1260 850 PCFV30-6R8M-RC 6.8 20 1 .310 780 760 PCFV30-100M-RC PCFV30-150M-RC PCFV30-220M-RC PCFV30 10 15 22 1 1 1 20 20 20 .430 .625 .870 570 500 420 560 490 410 100 150 220 All specifications subject to change without notice. Inductance vs. DC Current 25 Features • • • • Semi Magnetically Shielded High Current Low DC Resistence Ultra Low Profile, 1.02mm Electrical Inductance Range: 1.5µh ~ 22µh (other values being added) Tolerance: Available in 20% Operating Temp: -55ºC ~ +125ºC Isat: Current at which the Inductance will drop by no more then 30% of its initial value. Irms: Based on a temp rise of ∆ T = 40ºC typical above Ambient Temp. Resistance to Soldering Heat L(uH) 20 220 Pre-Heat 150ºC, 1 Min. Solder Composition: Sn/Ag3.0/Cu0.5 Solder Temp: 260ºC +/- 5ºC for 10 sec 15 150 10 100 6R8 5 Test Equipment 4R7 2R2 1R5 0 0 0.2 0.4 0.6 0.8 1 1.2 1.4 1.6 1.8 2 2.2 2.4 2.6 DC Current(A) (L): HP4287A + HP16197A (RDC): Chroma MilliOhm Meter 16502 Current: HP4284A + HP42841A Physical Tem perature Change vs. DC Current 70 60 220 150 100 Packaging: 2000 per Tape and reel Marking: EIA Inductance code 1R5 6R8 2R2 4R7 △ T(℃ ) 50 40 30 20 10 0 0 0.2 0.4 0.6 0.8 1 1.2 1.4 1.6 1.8 2 DC Current(A) 949-356-1780 ALLIED COMPONENTS INTERNATIONAL REVISED 15 04/22/14 www.alliedcomponents.com