MICRO(TO-92S) type taping specification 1.Taping specifications All models of MICRO(TO-92S) package product is wrapped to tape. As for the taping, radial tape is used. The tape shall be folded and then packaged in a box For more information about taping dimensions, please refer to figure 1. tape shape and dimensions. About specifications of accordion type and dimensions of box , please refer to figure 2. It is not coped about the rose product now. 2.Ordering unit It is wrapped 2,500 by one reel. Please inquire for the other packing specifications. -1- figure 1. tape shape and dimensions. P P2 Δh W2 W3 W4 △C F2 MARKING T d W0 H0 t W W1 H F1 Δh’ D0 P0 Enlarged view(F1、F2) F1 F2 Unit:mm Item Symbol Component thickness Lead diameter Dimensions Angle T 2.5 d 0.4 +0.1 -0.1 +0.05 -0.05 Inserted lead length(1) W3 2.5 MIN Inserted lead length (2) W4 2.0 MIN Component pitch P 12.7 Sprocket hole pitch P0 12.7 Sprocket hole location(1) P2 6.35 F1, F2 2.5 Lead spacing Component inclination (1) +1.0 -1.0 +0.3 -0.3 +0.5 -0.5 +0.4 -0.4 +1.0 -1.0 +1.0 -0.5 +0.5 -0.5 +0.75 -0.50 △h 0 W 18.0 Hold-down tape width W0 6.0 Sprocket hole location (2) W1 9.0 Tape misalignment W2 0.5 MAX H 19.5 MIN Carrier tape width Component package bottom height Lead clinch height H0 16.0 Sprocket hole diameter D0 4.0 Component inclination (2) △C 0 Lead form △h' 0 t 0.7 Tape thickness -2- +0.5 -0.5 +0.2 -0.2 +1.0 -1.0 +1.0 -1.0 +0.2 -0.2 figure 2.Specifications of accordion type and dimensions of box (1)Specifications of accordion type .5mm) 25個分(約317 25 components (approx317.5mm) 折り目 Fold 目 Fold 折り After lead-taping is completed, the tape shall be folded and then packaged in a box, as shown below. Hold down tape 台紙 Top 上面 ふた Lid 側面 Side (2)Dimensions of box 180 mm 335mm 330 Top 上面 50 mm ふた1 Lid1 ふた2 Lid2 側面 Side ミシン目 Perforation -3- テー ピング品 Taping