Electrical Parameter Terminology

SCRs
Electrical Parameter Terminology
Diode Rectifiers
di/dt (Critical Rate-of-rise of On-state Current) - Maximum
value of the rate-of-rise of on-state current which a Thyristor
can withstand without deleterious effect.
RRJC (Thermal Resistance, Junction-to-case) - Temperature
difference between the Thyristor junction and the Thyristor
case divided by the power dissipation causing the temperature
difference under conditions of thermal equilibrium.
dv/dt (Critical Rate-of-rise of Off-state Voltage or Static
dv/dt) - Minimum value of the rate-of-rise of principal voltage
which will cause switching from the off state to the on state.
tgt (Gate-controlled Turn-on Time) - Time interval between
the 10% rise of the gate pulse and the 90% rise of the
principal current pulse during switching of a Thyristor from the
off state to the on state.
dv/dt(c) Critical Rate-of-rise of Commutation Voltage of a
Triac (Commutating dv/dt) - Minimum value of the rateof-rise of principal voltage which will cause switching from
the off state to the on state immediately following on-state
current conduction in the opposite quadrant.
tq (Circuit-commutated Turn-off Time) - Time interval
between the instant when the principal current has decreased
to zero after external switching of the principal voltage circuit
and the instant when the SCR is capable of supporting a
specified principal voltage without turning on.
I2t (RMS Surge (Non-repetitive) On-state Fusing Current)Measure of let-through energy in terms of current and time
for fusing purposes.
VBO (Breakover Voltage) - Principal voltage at the breakover
point.
IBO(Breakover Current) - Principal current at the breakover
point.
VDRM (Repetitive Peak Off-state Voltage) - Maximum
allowable instantaneous value of repetitive off-state voltage
that may be applied across a bidirectional Thyristor (forward or
reverse direction) or SCR (forward direction only).
IDRM(Repetitive Peak Off-state Current) - Maximum leakage
current that may occur under the conditions of VDRM.
IGT(Gate Trigger Current) - Minimum gate current required to
switch a Thyristor from the off state to the on state.
IH (Holding Current) - Minimum principal current required to
maintain the Thyristor in the on state.
IPP (Peak Pulse Current) - Peak pulse current at a short time
duration and specified waveshape.
IRRM (Repetitive Peak Reverse Current) - Maximum leakage
current that may occur under the conditions of VRRM.
IS (Switching Current) - Current at VS when a SIDAC switches
from the clamping state to on state.
VGT (Gate Trigger Voltage) - Minimum gate voltage required
to produce the gate trigger current.
VRRM (Repetitive Peak Reverse Voltage) - Maximum
allowable instantaneous value of a repetitive reverse voltage
that may be applied across an SCR without causing reverse
current avalanche.
VS (Switching Voltage) - Voltage point after VBO when a
SIDAC switches from a clamping state to on state.
VT (On-state Voltage) - Principal voltage when the Thyristor
is in the on state.
Diode Rectifiers
IT(RMS) (On-state Current) - Anode cathode principal current
that may be allowed under stated conditions, usually the fullcycle RMS current.
IF(AV) (Average Forward Current) - Average forward
conduction current.
ITSM (Surge (Non-repetitive) On-state Current) - Peak single
cycle AC current pulse allowed.
IFM (Maximum (Peak) Reverse Current) - Maximum reverse
leakage current that may occur at rated VRRM.
PG(AV) (Average Gate Power Dissipation) - Value of gate
power which may be dissipated between the gate and main
terminal 1 (or cathode) average over a full cycle.
I(RMS) (RMS Forward Current) - RMS forward conduction
current.
PGM (Peak Gate Power Dissipation) - Maximum power which
may be dissipated between the gate and main terminal 1 (or
cathode) for a specified time duration.
RRJA (Thermal Resistance, Junction-to-Ambient) Temperature difference between the Thyristor junction
and ambient divided by the power dissipation causing
the temperature difference under conditions of thermal
equilibrium.
Note: Ambient is defined as the point where temperature
does not change as a result of the dissipation.
Specifications are subject to change without notice.
Please refer to http://www.littelfuse.com for current information.
IFSM (Maximum (Peak) Forward (Non-repetitive) Surge
Current) - Maximum (peak) forward single cycle AC surge
current allowed for specified duration.
VFM (Maximum (Peak) Forward Voltage Drop) - Maximum
(peak) forward voltage drop from the anode to cathode at
stated conditions.
VR (Reverse Blocking Voltage) - Maximum allowable DC
reverse blocking voltage that may be applied to the rectifier.
VRRM (Maximum (Peak) Repetitive Reverse Voltage) Maximum peak allowable value of a repetitive reverse voltage
that may be applied to the rectifier.
Introduction
Teccor® brand Thyristors