LPV-35 series

L P V- 3 5
35W Single Output Switching Power Supply
series
■ Features :
Constant voltage design
Universal AC input / Full range
Withstand 300VAC surge input for 5 seconds
Protections: Short circuit / Overload / Over voltage
Cooling by free air convection
Fully encapsulated with IP67 level (Note.9)
Fully isolated plastic case
Class Ⅱ power unit, no FG
Class 2 power unit
Pass LPS
Suitable for LED lighting and moving sign applications (Note.8)
100% full load burn-in test
Low cost, high reliability
2 years warranty
F
LPS IP67
110
SPECIFICATION
MODEL
OUTPUT
LPV-35-5
LPV-35-12
LPV-35-15
LPV-35-24
LPV-35-36
DC VOLTAGE
5V
12V
15V
24V
36V
RATED CURRENT
5A
3A
2.4A
1.5A
1A
CURRENT RANGE
0 ~ 6A (Note.7)
0 ~ 3A
0 ~ 2.4A
0 ~ 1.5A
0 ~ 1A
RATED POWER
30W
36W
36W
36W
36W
RIPPLE & NOISE (max.) Note.2 80mVp-p
120mVp-p
120mVp-p
150mVp-p
150mVp-p
VOLTAGE TOLERANCE Note.3 ±6.0%
±5.0%
85%
85%
±1.0%
LINE REGULATION
SETUP, RISE TIME
Note.6 500ms, 20ms / 230VAC
HOLD UP TIME (Typ.)
VOLTAGE RANGE
INPUT
50ms/230VAC
Note.4 90 ~ 264VAC
47 ~ 63Hz
77%
AC CURRENT (Typ.)
INRUSH CURRENT(Typ.)
1.1A/115VAC 0.7A/230VAC
COLD START 55A(twidth=510μs measured at 50% Ipeak) at 230VAC
MAX. No. of PSUs on 16A
CIRCUIT BREAKER
4 units (circuit breaker of type B) / 7 units (circuit breaker of type C) at 230VAC
OVERLOAD
OVER VOLTAGE
WORKING TEMP.
WORKING HUMIDITY
ENVIRONMENT STORAGE TEMP., HUMIDITY
TEMP. COEFFICIENT
OTHERS
84%
84%
0.25mA / 240VAC
110 ~ 150% rated output power
Protection type : Hiccup mode, recovers automatically after fault condition is removed
5.75 ~ 6.75V
13.8 ~ 16.2V
17.25 ~ 20.25V
27.6 ~ 32.4V
41.4 ~ 48.6V
Protection type : Shut down o/p voltage, re-power on to recover
-30 ~ +65℃ (Refer to "Derating Curve")
20 ~ 90% RH non-condensing
-40 ~ +80℃, 10 ~ 95% RH
VIBRATION
±0.03%/℃ (0 ~ 50℃)
10 ~ 500Hz, 2G 10min./1cycle, period for 60min. each along X, Y, Z axes
SAFETY STANDARDS
UL1310 class 2, CAN/CSA No. 223-M91, CB IEC61347-1,IEC61347-2-13,IP67 approved ; design refer to TUV EN60950-1
WITHSTAND VOLTAGE
I/P-O/P:3KVAC
ISOLATION RESISTANCE
I/P-O/P:>100M Ohms / 500VDC / 25℃/ 70% RH
Compliance to EN55022 (CISPR22) Class B, EN61000-3-2 Class A, EN61000-3-3
EMC EMISSION
EMC IMMUNITY
Compliance to EN61000-4-2,3,4,5,6,8,11, EN55024, light industry level, criteria A
MIL-HDBK-217F (25℃)
MTBF
743.5Khrs min.
DIMENSION
148*40*30mm (L*W*H)
0.34Kg; 40pcs/14.6Kg/0.63CUFT
PACKING
NOTE
16ms/115VAC at full load
127 ~ 370VDC
EFFICIENCY (Typ.)
PROTECTION
EMC
500ms, 20ms / 115VAC at full load
FREQUENCY RANGE
LEAKAGE CURRENT
SAFETY &
±2.0%
±4.0%
LOAD REGULATION
1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25℃ of ambient temperature.
2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.
3. Tolerance : includes set up tolerance, line regulation and load regulation.
4. Derating may be needed under low input voltage. Please check the static characteristics for more details.
5. The power supply is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the
complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again.
6. Length of set up time is measured at first cold start. Turning ON/OFF the power supply may lead to increase of the set up time.
7. LPV-35-5 can provide 6A of output current continuously. Based on the requirement of UL1310 class 2, the output current is only certified up to 5A for
the test report of LPV-35-5.
8. The unit might not be suitable for lighting applications in EU countries. Please check with your local authorities for the possible use of the unit.
9. Suitable for indoor use or outdoor use without direct sunlight exposure. Please avoid immerse in the water over 30 minute.
File Name:LPV-35-SPEC 2015-05-28
L P V- 3 5
35W Single Output Switching Power Supply
Mechanical Specification
Case No.975A
600±30
series
Unit:mm
600±30
148
UL1015 18AWG
3.6
T case ψ26.5
40
3.6
3.5
ψ
UL1007 16AWG
+V(Red)
-V(Black)
18
AC/N(Blue)
AC/L(Brown)
3.5
3.5
3.5
30
※ T case: Max. Case Temperature.
Recommend Mounting Direction
Block Diagram
fosc : 65KHz
EMI FILTER
&
RECTIFIERS
I/P
RECTIFIERS
&
FILTER
POWER
SWITCHING
O.L.P.
+V
-V
DETECTION
CIRCUIT
PWM
CONTROL
O.V.P.
Derating Curve
Static Characteristics
100
100
24~36V
90
80
80
5~15V
70
LOAD (%)
LOAD (%)
60
40
20
-30
0
15
30
40
50 55 60 65 70
AMBIENT TEMPERATURE (℃)
80 (HORIZONTAL)
60
50
40
90
100
125
135
145
155 165
175
180
200
230
264
INPUT VOLTAGE (V) 60Hz
File Name:LPV-35-SPEC 2015-05-28