MOSPEC MB2S THRU MB10S Voltage Range 200 to 1000 Volts Current 0.8 Amperes Single Phase 0.8 AMPS. Glass Passivated Bridge Rectifiers MBS .014(0.35) .006(0.15) Features .083(2.12) .043(1.10) • Ideal for printed circuit board • Reliable low cost construction technique results in inexpensive product .157(4.00) .142(3.60) • High temperature soldering guaranteed: .008(0.20) MAX .276(7.0) MAX 260℃ / 10 seconds / 0.375” ( 9.5mm ) lead length at 5 lbs., ( 2.3 kg ) tension .043(1.10) .028(0.70) .102(2.60) .087(2.20) Mechanical Data .053(1.53) .037(0.95) .193(4.90) .177(4.50) • Case: Molded plastic • Lead: solder plated • Polarity: As marked .053(1.53) .037(0.95) .106(2.70) .090(2.30) .118(3.0) MAX .033(0.84) .022(0.56) Dimensions in inches and (millimeters) MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS Rating at 25℃ ambient temperature unless otherwise specified. Single phase, half wave, 60 Hz, resistive or inductive load. For capacitive load, derate current by 20% Type Number MB2S MB4S MB6S MB8S MB10S UNITS Maximum Repetitive Peak Reverse Voltage VRRM 200 400 600 800 1000 V Maximum RMS Voltage VRMS 140 280 420 560 700 V VDC 200 400 600 800 1000 V Maximum DC blocking Voltage Maximum Average Forward Rectified Current On glass-epoxy P.C.B. On aluminum substrate Peak Forward Surge Current, 8.3 ms Single Half Sine-wave Superimposed on Rated Load (JEDEC method ) Maximum Instantaneous Forward Voltage @ 0.4A Maximum DC Reverse Current @ TA=25℃ rated DC blocking voltage per leg TA = 125℃ Typical Thermal Resistance (Note1) (Note2) Operating Temperature Range Storage Temperature Range I(AV) 0.5 0.8 A IFSM 35 A VF 1.0 V IR 5.0 500 μA RθJA RθJL 70 20 ℃/W TJ -55 to +150 ℃ TSTG -55 to +150 ℃ NOTES：1.On aluminum suvstrate P.C.B. with an area of 0.8×0.8”(20×20mm) mounted on 0.05×0.05”(1.3×1.3mm) solder pad. 2.On glass epoxy P.C.B. mouted on 0.05×0.05”(1.3×1.3mm) pads. MOSPEC MB2S THRU MB10S RATING AND CHARACTERISTIC CURVES DM-A