D3UB05 THRU D3UB100 Voltage Range 50 to 1000 Volts Current 3.0 Amperes Package:D3K Single Phase 3.0 AMPS. Glass Passivated Bridge Rectifiers Features • Ideal for printed circuit boards • Reliable low cost construction technique results in inexpensive product • High temperature soldering guaranteed: 260℃ / 10 seconds Mechanical Data • • • • • Case: Molded plastic Lead: solder plated Polarity: As marked on body Mounting Torque: 0.8N·m Recommended Torque: 0.5N·m MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS Rating at 25℃ ambient temperature unless otherwise specified. Single phase, half wave, 60 Hz, resistive or inductive load. For capacitive load, derate current by 20% Type Number D3UB 05 D3UB 10 D3UB 20 D3UB 40 D3UB 60 D3UB 80 D3UB 100 UNITS Maximum Repetitive Peak Reverse Voltage VRRM 50 100 200 400 600 800 1000 V Maximum RMS Voltage VRMS 35 70 140 280 420 560 700 V VDC 50 100 200 400 600 800 1000 V Maximum DC blocking Voltage Maximum Average Forward TC= 100℃ Rectified Current at TA= 40℃ Peak Forward Surge Current, 8.3 ms Single Half Sine-wave Superimposed on Rated Load (JEDEC method ) Maximum Instantaneous Forward Voltage @ 3A Rating for fusing (3ms≤t<8.3ms) Tj=25℃ Maximum DC Reverse Current @ TA=25℃ rated DC blocking voltage per leg TA = 125℃ Typical Thermal Resistance (Note) Operating Temperature Range Storage Temperature Range NOTE: IF(AV) (1) 3.0 (2) 2.0 A IFSM 60 A VF I 2t 1.1 15 A sec IR 5.0 500 μA RθJA RθJL 40 15 ℃/W TJ -55 to +150 ℃ TSTG -55 to +150 ℃ V 2 1.Unit case mounted on 1.6*1.6*0.06” thick (5.1*5.1*0.15cm) Al.Plate 2.Unit mounted on P.C.B. with 0.5*0.5” (12.7*1.27mm) copper pads and 0.375” (9.5mm) lead length Page 1 of 2 lizhenhui MB:+86-13537087568 E-mail:[email protected] RATING AND CHARACTERISTIC CURVES D3UB05 THRU D3UB100 Page 2 of 2 lizhenhui MB:+86-13537087568 E-mail:[email protected]