CONDUCTIVE POLYMER ALUMINUM SOLID ELECTROLYTIC CAPACITORS F8 Low ESR / ESL, Low Profile (φ5) series Low ESR/ESL, High ripple current. Low Profile(Height 8mm). Load life of 2000 hours at 105°C. Radial lead type : Lead free flow soldering condition correspondence. Compliant to the RoHS directive (2011/65/EU). S8 Lower ESL F8 Specifications Item Performance Characteristics Category Temperature Range –55 to +105°C Rated Voltage Range 2.5 to 6.3V Rated Capacitance Range 100 to 560µF Capacitance Tolerance ±20% at 120Hz, 20°C Tangent of loss angle (tan δ) Less than or equal to the specified value at 120Hz, 20°C ESR ( 1) Less than or equal to the specified value at 100kHz, 20°C Leakage Current ( 2) Less than or equal to the specified value. Endurance After 2 minutes' application of rated voltage at 20°C Test condition 105°C, rated voltage 2000Hrs. Capacitance change Within ±20% of initial value before test tan δ 150% or less than the initial specified value ESR( 1) 150% or less than the initial specified value Leakage current ( 2) Less than or equal to the initial specified value 1 ESR should be measured at both of the terminal ends closest where the terminals protrude through the plastic platform. 2 Conditioning : If any doubt arises, measure the leakage current after the voltage treatment of applying DC rated voltage continuously to the capacitor for 120 minutes at 105°C. Size List Cap [µF] R.V.(V) S.V.( V) 100 Aluminum case [φD×L(mm)] 2.5 4.0 6.3 2.8 4.6 7.2 Stand off Wire(Lead free) 5×8 270 5×8 330 5×8 470 5×8 560 5×8 5×8 5×8 (mm) Dimension table in next page. φD×L φd P α 5×8 0.6 2.0 1.0 CAT.8100D CONDUCTIVE POLYMER ALUMINUM SOLID ELECTROLYTIC CAPACITORS F8 series Standard Ratings Rated Voltage Surge Voltage (V) (V) (code) 2.5 (0E) Rated Case Size Capacitance φD×L (mm) (µF) 4.6 6.3 (0J) 7.2 Leakage Rated Ripple ESL ESR Current Current (Typ.) (mΩ, 100kHz) (µA, 2min.) (nH, 10MHz) (mArms) NICHICON FPCAP 100 5×8 0.10 500 7 1.5 4200 RF80E101MDN1□□ FP-2R5RE101M-F8□□ 330 5×8 0.10 500 7 1.5 4200 RF80E331MDN1□□ FP-2R5RE331M-F8□□ 470 5×8 0.10 500 7 1.5 4200 RF80E471MDN1□□ FP-2R5RE471M-F8□□ 560 5×8 0.10 500 7 1.5 4200 RF80E561MDN1□□ FP-2R5RE561M-F8□□ 330 5×8 0.10 500 8 1.5 4000 RF80G331MDN1□□ FP-4R0RE331M-F8□□ 270 5×8 0.10 500 11 1.5 3700 RF80J271MDN1□□ FP-6R3RE271M-F8□□ 330 5×8 0.10 500 11 1.5 3700 RF80J331MDN1□□ FP-6R3RE331M-F8□□ 2.8 4.0 (0G) tan δ Frequency Characteristics (The frequency characteristics are typical and not a guaranteed value.) 2.5V 560µF Impedance 2.5V 560µF Frequency (kHz) Frequency (kHz) Taping specifications are given in page 26, 27. Please refer to page 3 for the minimum order quantity. CAT.8100D