Constant current dimmable LED Drivers For indoor use LNSB-30C Series, 30 Watt, 1-10V Dimmable FEATURES: Constant current output Active power factor correction, class 1-10V dimmable Short circuit, over load and over temperature protections Designed to worldwide safety standards for lighting Cooling by free air convection 5 year warranty Model LNSB30-C500D LNSB30-C700D Ⅱ power Nominal Input voltage (Vac) 220-240 Output current (mA) Output voltage (Vdc) Output power (W) Min. Max. 500 20 60 30 700 18 54 30 ELECTRICAL Input Parameters Symbols Test Conditions / Comment Min. Typ. Max. Units Input voltage Vin --- 198 -- 264 Vac Input frequency Fline --- 47 -- 63 Hz LNSB30-C500D -- -- 140 mA LNSB30-C700D -- -- 180 mA Input current Iin Inrush current Iinrush Cold start, 250μs -- -- 15 A Power factor PF Full load -- 0.95 -- PF η Full voltage, full load -- 83 -- % Efficiency www.pairuigroup.com Page: 1 / 4 Date: 07/18/2015 *Subject to change without prior notice. Constant current dimmable LED Drivers For indoor use LNSB-30C Series, 30 Watt, 1-10V Dimmable ELECTRICAL Output Parameters Output current Output voltage Turn-on time Ripple Symbols Iout Vout Tturn-on Iripple Test Conditions / Comment Min. Typ. Max. Units LNSB30-C500D 475 500 525 mA LNSB30-C700D 665 700 735 mA LNSB30-C500D 20 54 60 V LNSB30-C700D 18 43 54 V Cold start, power on -- -- 0.5 S LNSB30-C500D -- 100 -- LNSB30-C700D -- 140 -- mAp-p Protection Over voltage Over temperature Short circuit The voltage will fluctuates in the vicinity of the protection value, it will recover automatically after fault condition is removed No output when exceeds temperature protection point, it will recover automatically after the temperature falls below the threshold value In hiccup mode, it will recover automatically after fault condition is removed Environment Storage Ambient operating temperature Maximum case temperature Operating relative humidity Tstorage Humidity: 5% RH to 85% RH -30 -- +80 ℃ Ta Startup at rated voltage -20 -- +50 ℃ Tc Hot-spot on case -- -- +75 ℃ Ha Non condensing 5 -- 85 % -- 35 -- kHrs Full load, MTBF TMTBF (output current: 500mA) 80℃ ambient temperature Dimming operation Use a 1~10Vdc signal to adjust the output current value by input AC(L) terminal Waterproof Dimension(LxWxH) IP20 188.0 x 45.0 x 29.0mm Weight www.pairuigroup.com 175g Page: 2 / 4 Date: 07/18/2015 *Subject to change without prior notice. Constant current dimmable LED Drivers For indoor use LNSB-30C Series, 30 Watt, 1-10V Dimmable ELECTRICAL Safety / EMC Safety standards Design refer to EN61347-1, EN61347-2-13 EMC Design refer to EN55015, EN61000-3-2, EN61547, EN62384, EN62493 Notes: Unless otherwise specified, all the above parameters are measured at ambient temperature of 25 Vin = 220Vac to 240Vac. ℃ and MECHANICAL Unit: mm ELECTRICAL CURVE PF vs Load www.pairuigroup.com Page: 3 / 4 Date: 07/18/2015 *Subject to change without prior notice. Constant current dimmable LED Drivers For indoor use LNSB-30C Series, 30 Watt, 1-10V Dimmable ELECTRICAL CURVE Efficiency vs Load NOTE DIMMING CONNECTION 1~10V DIMMING Dimming value 1V 2V 3V 4V 5V 6V 7V 8V 9V 10V Luminous 10% 20% 30% 40% 50% 60% 70% 80% 90% 100% www.pairuigroup.com Page: 4 / 4 Date: 07/18/2015 *Subject to change without prior notice.