Xeon 5 Power White LED OSXXXDE5E1E VER C.2 3.6 ■ Features ● Highest Luminous Flux ● Super Energy Efficiency ● Long Lifetime Operation ● Superior ESD protection ● Superior UV Resistance BackView ■ Applications ● Read lights (car, bus, aircraft) ● Portable (flashlight, bicycle) ● Bollards / Security / Garden ● Traffic signaling / Beacons ● In door / Out door Commercial lights ● ESD Protection Diode Unit:mm Tolerance:±0.30mm Automotive Ext ■ Absolute (Ta=25℃) Maximum Rating Item Symbol ■Directivity Value White/ Warm white Unit DC Forward Current IF 1600 mA Pulse Forward Current* IFP 2000 mA Reverse Voltage VR 5 V Power Dissipation PD 7200 mW Operating Temperature Topr -30 ~ +85 ℃ Storage Temperature Tstg -40~ +100 ℃ Lead Soldering Temperature Tsol 260℃/5sec ℃ *Pulse width Max.10ms ■ Electrical Cathode Anode 0 0 Duty ratio max 1/10 (Ta=25℃) VF (V) -Optical Characteristics Part Number Color OSW4XDE5E1E Pure White W4 OSM5XDE5E1E Warm White M5 IR(µA) Min. Typ. Max. Max. IF=1400mA VR=5V 3.3 3.3 3.5 3.5 4.5 10 4.5 10 CCT (K) Typ λD(nm) Luminous Flux Φv (lm) Min. Typ. (deg) Max. Min. Typ. Max. IF=1400mA 6500 300 320 - X=0.31 ,Y=0.33 3000 280 300 - X=0.44,Y=0.41 Note: Don’t drive at rated current more than 5s without heat sink for Xeon 5 emitter series. LED & Application Technologies http://www.optosupply.com 2θ1/2 VER A.0 140 Xeon 5 Power White LED OSXXXDE5E1E VER C.1 ■ Handling of Silicone Lens LEDs Notes for handling of silicone lens LEDs ● Please do not use a force of over 3kgf impact or pressure on the silicone lens, otherwise it will cause a catastrophic failure. ● The LEDs should only be picked up by making contact with the sides of the LED body. ● Avoid touching the silicone lens especially by sharp tools such as Tweezers. ● Avoid leaving fingerprints on the silicone lens. ● Please store the LEDs away from dusty areas or seal the product against dust. ● When populating boards in SMT production, there are basically no restrictions regarding the form of the pick and place nozzle, except that mechanical pressure on the silicone lens must be prevented. ● Please do not mold over the silicone lens with another resin. (epoxy, urethane, etc) LED & Application Technologies http://www.optosupply.com VER A.0