Xeon 1 Power Infrared Emitter LED OSI3XAE1C1E ■Features ■Outline ● Highest luminous flux ● Super energy efficiency ● Very long operating life ● Superior ESD protection Dimension Anode(+) 5 .1 1 3.6 2.0 Cathode(-) ■Applications BackView 5.5 Night Vision ● Camera ● Outdoor./Indoor applications 5 .0 6 5 . 3 .1 0 14.5 ■Absolute ℃ (Ta=25 ) Maximum Rating Item Value Unit DC Forward Current IF 1000 mA Pulse Forward Current* IFP 2000 mA Reverse Voltage VR 5 V Power Dissipation PD 1700 mW Operating Temperature Topr -30 ~ +85 Storage Temperature Tstg -40~ +100 Lead Soldering Temperature Tsol 260 ■Electrical ℃ ■Forward Operating Item Symbol Condition Min. Typ. Max. Unit DC Forward Voltage VF IF=350mA - 1.5 1.7 V DC Reverse Current IR VR=5V - - 0 - (Ta=25 ) -Optical Characteristics 0 ℃ ℃ ℃/5sec Duty ratio max 1/10 .2 0 ■Directivity Symbol *Pulse width Max.10ms Unit:mm Tolerance:±0.30mm 5 .0 1 10 µA Peak Wavelength λP IF=350mA - 850 - nm Radiant Power PO IF=350mA 110 - - mW 1000 2θ1/2 IF=350mA - 120 - Note: Advises please attach heat sink to use if Power Dissipation is more than 0.5W. LED & Application Technologies deg Rth(J-a)=20℃/W 800 Rth(J-a)=30℃/W 600 Rth(J-a)=40℃/W 400 200 0 0 50% Power Angle Current (DC) 1200 Forward Current, IF (mA) ● 20 40 60 Ambient Temperature, TA ( 80 ) 100 Xeon 1 Power Infrared Emitter LED OSI3XAE1C1E VER C.0 ■ Handling of Silicone Lens LEDs Notes for handling of silicone lens LEDs ● Please do not use a force of over 3kgf impact or pressure on the silicone lens, otherwise it will cause a catastrophic failure. ● The LEDs should only be picked up by making contact with the sides of the LED body. ● Avoid touching the silicone lens especially by sharp tools such as Tweezers. ● Avoid leaving fingerprints on the silicone lens. ● Please store the LEDs away from dusty areas or seal the product against dust. ● When populating boards in SMT production, there are basically no restrictions regarding the form of the pick and place nozzle, except that mechanical pressure on the silicone lens must be prevented. ● Please do not mold over the silicone lens with another resin. (epoxy, urethane, etc) LED & Application Technologies