Xeon 1 Power Pure Green &Red & Blue LED OSTCXBEAC1E ■Features Highest Luminous Flux ● Long Lifetime Operation ● Superior ESD protection ● Superior UV Resistance ● 2.85 ● ● ● ● ● Red Anode Mark Water Clear Type 4 3 Mobile Phone Flash Automotive Interior/Exterior Lighting / Signal Lighting Architectural Lighting LCD TV / Monitor Backlight Projector Light Source / Traffic Signals / Task Lighting Decorative / Pathway Lighting / Household Applications ■Absolute 6 0.2 ■Applications ● 5.4 1.0 14.5 Super Energy Efficiency 4.4 3 2 1 5.5 ● Dimension 7.3 ● ■Outline Maximum Rating Item Symbol 4 6 R 5 Back View 1 2 B (Ta=25℃) Value Green/Blue Red 5 G 4,5,6.Anode 1,2,3.Cathode Unit:mm Tolerance±0.30mm 6 ■Directivity Unit DC Forward Current IF 400 400 mA Pulse Forward Current* IFP 500 500 mA Reverse Voltage VR 5 5 V Power Dissipation PD 1200 1600 mW Operating Temperature Topr -30 ~ +85 ℃ Storage Temperature Tstg -40 ~ +100 ℃ Lead Soldering Temperature Tsol 260℃/5sec - 0 0 *Pulse width Max.10ms Duty ratio max 1/10 ■Electrical -Optical Characteristics Item DC Forward Voltage DC Reverse Current Domi. Wavelength Luminous Flux 50% Power Angle (Ta=25℃) Symbol Condition Min. Typ. Max. Unit VF (R) IF=350mA 2.0 2.5 3.0 V VF (B/G) IF=350mA 3.0 3.3 4.0 V IR VR=5V - - 10 µA λD(Red) IF=350mA 620 625 630 nm λD(Green) IF=350mA 520 525 535 nm λD(Blue) IF=350mA 455 460 465 nm Φv (Red) IF=350mA 40 50 - lm Φv (Green) IF=350mA 50 70 - lm Φv (Blue) IF=350mA 15 20 - lm 2θ1/2 IF=350mA - 120 - deg Note: Don’t drive at rated current more than 5s without heat sink for Xeon 1 Power emitter series. LED & Application Technologies http://www.optosupply.com VER A.0 Xeon 1 Power Pure Green &Red & Blue LED OSTCXBEAC1E ■ Handling of Silicone Lens LEDs Notes for handling of silicone lens LEDs ● Please do not use a force of over 3kgf impact or pressure on the silicone lens, otherwise it will cause a catastrophic failure. ● The LEDs should only be picked up by making contact with the sides of the LED body. ● Avoid touching the silicone lens especially by sharp tools such as Tweezers. ● Avoid leaving fingerprints on the silicone lens. ● Please store the LEDs away from dusty areas or seal the product against dust. ● When populating boards in SMT production, there are basically no restrictions regarding the form of the pick and place nozzle, except that mechanical pressure on the silicone lens must be prevented. ● Please do not mold over the silicone lens with another resin. (epoxy, urethane, etc) LED & Application Technologies http://www.optosupply.com VER A.0