40W Solid State Power BUC CPI Solid Inside and Out Ku- Band B3UO-2H Ku-Band 40 W Ku-band Solid State Block Upconverter — Environmentally sealed compact design for outdoor operation Global Applications With CPI-built RF brick inside and plenty of thermal margin, this SSPB is rock-solid and highly efficient. High LInearity Perfect for Satcom on the Move, Micro Flyaway Systems, VSATs, and antennamount applications. Meets Electromagnetic Compatibility Directive 2004/108/EC to satisfy worldwide requirements. Excellent AM/PM, phase noise and spectral regrowth performance. Worldwide Support Simple to Operate User-friendly microprocessor-controlled serial interface. Also contains digitally controlled attenuator. Backed by over three decades of satellite communications experience, and CPI’s worldwide 24-hour customer support network that includes sixteen regional factory service centers. Extended Band Operation Provides up to 40 watts of P1dB output power at the flange over the entire 13.75 to 14.50 GHz frequency range. 811 Hansen Way P.O. Box 51625, Palo Alto, CA 94303 tel: +1 (650) 846-3803 fax: +1 (650) 424-1744 e-mail: [email protected] www.cpii.com/satcom 40W Solid State BUC CPI-Built RF Brick Inside Ku -B a n d SPECIFICATIONS, 40 W Ku-Band Outdoor Solid State Power BUC (SSPB) (Model B3UO-2H) Electrical (continued) Electrical OPTIONS: • External Multiplexed 10 MHz reference 400 W max. 14.0 to 14.5 GHz or 13.75 to 14.5 GHz L-Band Input 950 to 1450 MHz or 950 to 1700 MHz Output Power 50 W Psat (47 dBm) 40 W P1dB (46 dBm) min. Local Oscillator Frequency 13,050 MHz or 12,800 MHz External 10 MHz Reference Phase Noise Requirement 2 dBm ± 5 dB @100 Hz -140 dBc/Hz @1 kHz -150 dBc/Hz @ 10 kHz -155 dBc/Hz External 10 MHz Reference Auto or software select BUC Stability w/ internal ref. ±1 ppm from -40°C to +55°C Environmental Small Signal Gain 70 dB min. Ambient Temperature Gain Stability Over temp., constant drive Over 24 hours, fixed temp. ±2.0 dB over oper. temp. range ±0.25 dB -40°C to +55°C operating in direct sunlight; -40°C to +60°C operating out of direct sunlight; -50°C to +85°C non-operating Gain Slope ±0.04 dB/MHz max. Relative Humidity 100% condensing Small Signal Gain Variation Across any 80 MHz band Across the full band ±0.85 dB pk-pk max. ±1.25 dB pk-pk max. Altitude 12,000 ft. with standard adiabatic derating of 2°C/1000 ft., operating; 50,000 ft., non-operating Gain Adjustment Range 20 dB Cooling Integral forced air Input VSWR 1.5:1 max. (50 ohms) Shock and Vibration Output VSWR 1.3:1 max. (50 ohms) with external waveguide isolator 20 g rms, 1/2 sine save non-operating, and MIL-STD-810, method 514-4, transport vibration Monitor and Control Load VSWR Continuous operation Full spec compliance :1 1.5:1 Residual AM, max. -80 dBc > 100 kHz from carrier Phase Noise, max. 100 Hz 1 kHz 10 kHz 100 kHz 1 MHz -63 dBc/Hz -73 dBc/Hz -83 dBc/Hz -93 dBc/Hz -103 dBc/Hz AM/PM Conversion 2.5°/dB max. for a single-carrier at 2.5 dB backoff from rated P1dB Spurious Response at P1dB -60 dBc max. in band Harmonics -40 dBc max. (-60 dBc with external filter) Noise Power Density <-150 dBW/4 kHz, receive band with external filter; <-70 dBW/4 kHz, passband Intermodulation Distortion -25 dBc max. with two equal carriers and 5 MHz apart at 3.0 dB total backoff from rated P1dB Group Delay (in any 80 MHz band) 0.03 ns/MHz linear max. 0.01 ns/MHz2 parabolic max. 1.0 ns pk-pk ripple max. Primary Power 24 or 48 V ±20% Certificate Number: 30515 For more detailed information, please refer to the corresponding CPI Technical Description. Note: Specifications may change without notice as a result of additional data or product refinement. Please contact CPI before using this information for system design. MKT 321C, ISSUE 7 Power Consumption Frequency 06/12 PDF Remote Control Transmit ON/OFF Fault Reset Attenuator Setting Computer/Network Interface RS485 Remote Status Summary Fault, Temperature, Fault Identification, Lock Detect, Hardware Enable Mechanical RF Output Connection WR-75 waveguide flange, grooved with UNC 2B 6-32 threaded holes L-Band Input Connection Type N female Power In and M&C Circular 32-pin MS3112E18-32F (power and M&C IP67) Dimensions (w x l x h) 5.25" x 13.8" x 4.50 " (134 x 351 x 115 mm) including isolator and connectors Weight 10.9 lbs (4.96 kg) typ.