ITAR FREE Ka-BAND SSPA 16W SSPA-290-310-011 29 GHz - 31 GHz Description This ITAR-FREE Ka-Band Solid State Power Amplifier (SSPA) is designed to meet the extended Ka-Band Satcom bands and is ideally suited for airborne or SWaP applications where size weight and power are critical. The unit produces over 10 W of Linear power over the full 2 GHz bandwidth from 29 to 31 GHz. Internal monitor and control includes over temperature alarm and transmit enable function. Other Products Low Noise Block Converters (Ku & X-Band) Block Up Converters (Ku & X-Band) Low Noise Amplifiers (Ku & K-Band) Solid State Power Amplifiers (X, Ku & Ka-Band) Synthesizers (L, C or X-Band) With a total weight of 1.36 lbs and approx size of 5” x 3.6” x 0.96” the unit is ideal for todays integrated light weight Ka-Band terminals. Features: Small Size Weight and Power Includes Forward Power Monitoring Wide Input Voltage Range High Speed Blanking Operates over 29 to 31 GHz Electronic Gain Control Internal Built in Test Alarm Hermetically Sealed Optimized for Linear Power ITAR-FREE TELEDYNE MICROWAVE SOLUTIONS Everywhereyoulook TM 1274 Terra Bella Avenue, Mountain View, CA 94043 Tel: 1.800.832.6869 or +1.650.962.6944 Fax: +1.650.962.6845 www.teledynemicrowave.com [email protected] Ka-BAND SSPA 16W 29 GHz - 31 GHz Parameter Value Operating Frequency Range 29 to 31 GHz Operating Temperature Range -55 to +70 °C Small-Signal Gain Range (Electronically Controlled) 33 dB to 53 dB PLinear @ +25C @ +70C +40 dBm (10 W) min +39.55 dBm (9 W) min P1dB @ +25C @ +70C +42.0 dBm (16 W) min +41.5 dBm (14 W) min DC Power Consumption 100 W max @ Linear Power DC Supply Voltage Range +20 to +36 VDC RF Input Connector Output Waveguide Flange DC Supply & Monitor / Control Connector 2.92mm (f) WR-28 with O-ring Groove 25 pin Ni Hermetic Connector Tx Enable <1 mS Input VSWR Output VSWR Spurious Parameter Value Modulation Defined As: QPSK/0QPSK, RRC Filter, Alpha = 0.20, 10 Msps. Spectral Regrowth Measured At: 1.0X symbol rate (or 10 MHz offset from center frequency) Value: -30 dBc Noise Figure 12 dB @ Max Gain 18 dB @ Min Gain Noise Power Density (29 - 31 GHz) -60 dBm/Hz max Noise Power Density (19.2 - 21.2 GHz) -140 dBm/Hz max Humidity 100% Size 5” X 3.6” X 0.96” Weight 1.36 lbs max 1.5:1 1.7:1 18.3 - 21.2 GHz In-Band Harmonics Max RF Input Power -60 dBc -60 dBc -20 dBc +11 dBm “ 03/15