FIGURE 1: SCHEMATIC DIAGRAM TABLE 1: ELECTRICAL SPECIFICATIONS AT 25 OC MIN. SPEC LIMITS TYP. MAX. UNITS 1 -------- 1CT:3CT -------- PRIMARY INDUCTANCE (TIE 2-3) VOLTAGE = 0.200Vrms @ 100KHz 180 PRIMARY DCR (1-2) 0.5 -------- -------- Ohm SECONDARY DCR (5-6) 4.0 -------- -------- Ohm HI-POT: BETWEEN ANY TWO WINDINGS 1800 -------- -------- -------- -------- 8 + 3% Hy PRIMARY TURNS RATIO'S: PRI : SEC #5 2 3 7 6 4 5 SECONDARY PARAMETER Vdc FIGURE 2: PHYSICAL DIMENSIONS IN INCHES, (mm) FIGURE 3: PCB LAYOUT 8 7 6 5 .50 (12.7) .075 (1.90) .100 (2.54) WHITE DOT DENOTES PIN #1 1 2 3 .45 (11.43) MAX 4 0.50 (1.27) 8-PL .23 (5.84) MAX P PMGD-61 M XXXX .100 (2.54) .03 (.76) .500 (12.7) UNLESS OTHERW ISE SPECIFIED DIMENSIONS ARE IN INCHES DIMENSIONAL TOLERANCES ARE: DECIMALS ANGLES .XX + .04 + 0 O 30' .XXX + .020 DO NOT SCALE DRAWING REV. DESCRIPTION OF CHANGES BY 03/01/04 ORIGINAL RELEASE PP GATE DRIVE TRANSFORMER CONTROL DRAWING PREMIER P/N: PMGD-61 REVISION: 03/01/04 DRAWN BY: PETER PHAM REF: SCALE: NONE SHEET: 1 OF 2