C3D08065E VRRM = Silicon Carbide Schottky Diode IF (TC=135˚C) = 12 A Z-Rec Rectifier ® Qc Features • • • • • • • 650 V = 20 nC Package 650-Volt Schottky Rectifier Zero Reverse Recovery Current Zero Forward Recovery Voltage High-Frequency Operation Temperature-Independent Switching Behavior Extremely Fast Switching Positive Temperature Coefficient on VF TO-252-2 Benefits • • • • • Replace Bipolar with Unipolar Rectifiers Essentially No Switching Losses Higher Efficiency Reduction of Heat Sink Requirements Parallel Devices Without Thermal Runaway PIN 1 CASE PIN 2 Applications • • • Switch Mode Power Supplies Power Factor Correction Motor Drives Part Number Package Marking C3D08065E TO-252-2 C3D08065 Maximum Ratings (TC = 25˚C unless otherwise specified) Symbol Value Unit Test Conditions VRRM Repetitive Peak Reverse Voltage 650 V VRSM Surge Peak Reverse Voltage 650 V VDC DC Blocking Voltage 650 V Continuous Forward Current 25.5 12 8 A TC=25˚C TC=135˚C TC=155˚C IF Note Fig. 3 IFRM Repetitive Peak Forward Surge Current 34 25 A TC=25˚C, tP = 10 ms, Half Sine Wave TC=110˚C, tP = 10 ms, Half Sine Wave IFSM Non-Repetitive Peak Forward Surge Current 71 60 A TC=25˚C, tp = 10 ms, Half Sine Wave TC=110˚C, tp = 10 ms, Half Sine Wave Fig. 8 IF,Max Non-Repetitive Peak Forward Surge Current 650 530 A TC=25˚C, tP = 10 µs, Pulse TC=110˚C, tP = 10 µs, Pulse Fig. 8 Power Dissipation 120 52 W TC=25˚C TC=110˚C Fig. 4 -55 to +175 ˚C Ptot TJ , Tstg 1 Parameter Operating Junction and Storage Temperature C3D08065E Rev. - Electrical Characteristics Symbol Parameter Typ. Max. Unit Test Conditions Note VF Forward Voltage 1.5 2.1 1.8 2.4 V IF = 8 A TJ=25°C IF = 8 A TJ=175°C Fig. 1 IR Reverse Current 10 20 50 200 μA VR = 650 V TJ=25°C VR = 650 V TJ=175°C Fig. 2 QC Total Capacitive Charge 20 nC VR = 650 V, IF = 8A di/dt = 500 A/μs TJ = 25°C Fig. 5 C Total Capacitance 395 37 32 pF VR = 0 V, TJ = 25°C, f = 1 MHz VR = 200 V, TJ = 25˚C, f = 1 MHz VR = 400 V, TJ = 25˚C, f = 1 MHz Fig. 6 EC Capacitance Stored Energy 3.0 μJ VR = 400 V Fig. 7 Note: 1. This is a majority carrier diode, so there is no reverse recovery charge. Thermal Characteristics Symbol RθJC Parameter Typ. Unit Note Thermal Resistance from Junction to Case 1.25 °C/W Fig. 9 Typical Performance 20 12 10 25 TJ = 25 °C TJ = 75 °C TJ = 125 °C IR (mA) 14 F FowardICurrent, (A) IF (A) 16 TJ = -55 °C Reverse Leakage Current, IRR (mA) 18 30 TJ = 175 °C 8 6 4 2 TJ = 175 °C TJ = 125 °C 15 TJ = 75 °C 10 TJ = 25 °C TJ = -55 °C 5 0 0 0.0 0.5 1.0 1.5 2.0 2.5 3.0 3.5 0 200 400 600 800 1000 1200 FowardVVoltage, (V) VF (V) F Figure 1. Forward Characteristics 2 20 C3D08065E Rev. - 4.0 0 100 200 300 400 500 600 700 800 900 1000 ReverseVVoltage, (V) VR (V) R Figure 2. Reverse Characteristics Typical Performance 90 140 10% Duty 20% Duty 30% Duty 50% Duty 70% Duty DC 80 70 100 50 (W) PP Tot(W) TOT IF(peak) (A) IF (A) 60 120 40 30 80 60 40 20 20 10 0 0 25 50 75 100 125 150 25 175 50 75 175 Figure 4. Power Derating 450 Conditions: TJ = 25 °C Conditions: TJ = 25 °C Ftest = 1 MHz Vtest = 25 mV 400 350 20 Capacitance C (pF)(pF) CapacitiveQCharge, (nC) QC (nC) C 150 C Figure 3. Current Derating 25 125 ˚C TTC (°C) T ˚C TCC(°C) 30 100 15 10 300 250 200 150 100 5 50 0 0 100 200 300 400 500 600 700 ReverseVVoltage, (V) VR (V) R Figure 5. Total Capacitance Charge vs. Reverse Voltage 3 C3D08065E Rev. - 0 0 1 10 100 (V) VR (V) ReverseVVoltage, R Figure 6. Capacitance vs. Reverse Voltage 1000 Typical Performance 1,000 8 6 IIFSM (A) (A) 5 FSM 4 C Capacitance StoredE Energy, µJ) (mJ) EC (µ 7 3 100 TJ = 25 °C TJ = 110 °C 2 1 0 0 100 200 300 400 500 600 10 10E-6 700 ReverseVVoltage, (V) VR (V) 0.5 0.3 100E-3 0.1 0.05 0.02 SinglePulse 0.01 10E-3 1E-3 1E-6 10E-6 100E-6 1E-3 Time, tp (s) T (Sec) 10E-3 Figure 9. Transient Thermal Impedance 4 C3D08065E Rev. - 10E-3 Figure 8. Non-repetitive peak forward surge current versus pulse duration (sinusoidal waveform) Figure 7. Capacitance Stored Energy Thermal Resistance (oC/W) Thermal Resistance (˚C/W) 1E-3 tp (s) Time, tp (s) R 1 100E-6 100E-3 1 Package Dimensions POS Package TO-252-2 * Inches Millimeters Min Max Min Max A .250 .289 6.350 7.341 B .197 .215 5.004 5.461 C .027 .050 .686 1.270 D* .270 .322 6.858 8.179 E .178 .182 4.521 4.623 F .025 .045 .635 1.143 G 44˚ 46˚ 44˚ 46˚ H .380 .410 9.652 10.414 J .090 TYP 2.286 TYP K 6˚ 8˚ 6˚ 8˚ 2.388 L .086 .094 2.184 M .018 .034 .457 .864 N .035 .050 .889 1.270 P .231 .246 5.867 6.248 Q 0.00 .005 0.00 .127 R R0.010 TYP R0.254 TYP S .017 .023 .432 .584 T .038 .045 .965 1.143 U .021 .029 .533 .737 Note: * Tab “D” may not be present Recommended Solder Pad Layout TO-252-2 Part Number Package Marking C3D08065E TO-252-2 C3D08065 Note: Recommended soldering profiles can be found in the applications note here: http://www.cree.com/power_app_notes/soldering 5 C3D08065E Rev. - Diode Model Diode Model CSD04060 Vf T = VT + If*RT VT= 0.965 + (Tj * -1.3*10-3) RT= 0.096 + (Tj * 1.06*10-3) VfT = VT + If * RT VT = 0.95 + (TJ * -1.2*10-3) RT = 0.054 + (TJ * 5.5*10-4) VT RT Note: Tj = Diode Junction Temperature In Degrees Celsius, valid from 25°C to 175°C Notes • RoHS Compliance The levels of RoHS restricted materials in this product are below the maximum concentration values (also referred to as the threshold limits) permitted for such substances, or are used in an exempted application, in accordance with EU Directive 2011/65/EC (RoHS2), as implemented January 2, 2013. RoHS Declarations for this product can be obtained from your Cree representative or from the Product Documentation sections of www.cree.com. • REACh Compliance REACh substances of high concern (SVHCs) information is available for this product. Since the European Chemical Agency (ECHA) has published notice of their intent to frequently revise the SVHC listing for the foreseeable future,please contact a Cree representative to insure you get the most up-to-date REACh SVHC Declaration. REACh banned substance information (REACh Article 67) is also available upon request. • This product has not been designed or tested for use in, and is not intended for use in, applications implanted into the human body nor in applications in which failure of the product could lead to death, personal injury or property damage, including but not limited to equipment used in the operation of nuclear facilities, life-support machines, cardiac defibrillators or similar emergency medical equipment, aircraft navigation or communication or control systems, or air traffic control systems. Related Links • • • Cree SiC Schottky diode portfolio: http://www.cree.com/diodes C3D Spice models: http://response.cree.com/Request_Diode_model SiC MOSFET and diode reference designs: http://response.cree.com/SiC_RefDesigns Copyright © 2014 Cree, Inc. All rights reserved. The information in this document is subject to change without notice. Cree, the Cree logo, and Zero Recovery are registered trademarks of Cree, Inc. 6 C3D08065E Rev. - Cree, Inc. 4600 Silicon Drive Durham, NC 27703 USA Tel: +1.919.313.5300 Fax: +1.919.313.5451 www.cree.com/power