AAF-03 SERIES AC/DC Power Module 3W FEATURES ►Fully Encapsulated Plastic Case for PCB Mounting ►Universal Input 85~264VAC, 47~440Hz ►Protection Class II as per IEC/EN 60536 ►Operating Temp. Range -25°C to +70°C ►Overload/Voltage and Short Circuit Protection ►EMI Emission meets EN55011/22 Class B & FCC Level B ►EMC Immunity meets EN61000-4-2,3,4,5,6,8,11 ►Eco Design, Low No Load Power Consumption < 150mW ►UL/cUL/IEC/EN 60950-1, TUV/IEC/EN60335-1 Safety Approval ►CE Marking with EMC and LVD PRODUCT OVERVIEW The new AAF-03 Series from MINMAX is a range of ultra-small,fully encapsulated 3 Watt AC/DC power supply modules.They are designed for easy PCB mounting with solder pins.The modules feature EMI-filter to meet EN 55011/55022,class B and EN 55014.EMC immunity complies with EN 61000-6-1.The low stand-by power consumption complies with European ErP Directive 2009/125/EC. Universal input voltage range of 85-264VAC and an International safety approval package qualifies the power modules for worldwide markets. The AAF-03 series provide a cost effective solution for space critical applications in consumer appliances and instrumentation and communication equipment. Model Selection Guide Model Number Output Voltage Output Current Input Current Max. capacitive Load Efficiency (typ.) Max. Peak(1) @Max. Load VDC mA mA mA(typ.) μF @Max. Load % AAF-03S03 3.3 900 1170 62 1200 70 AAF-03S05 5 600 780 61 820 72 AAF-03S09 9 333 430 57 470 77 AAF-03S12 12 250 320 56 330 78 AAF-03S15 15 200 260 56 270 78 AAF-03S24 24 125 160 56 180 78 Input Specifications Parameter Model Input Voltage Range Input Frequency Range All Models Input Voltage Range No-Load Power Consumption Inrush Current (Cold Start at 25℃) E-mail:[email protected] 2015/05/22 REV:5 Typ. Max. Unit 85 --- 264 VAC 47 --- 63 Hz 120 --- 370 VDC --- --- 150 mW 115VAC --- --- 15 A 230VAC --- --- 25 A Tel:886-6-2923150 Page 1 of 3 Min. AAF-03 SERIES AC/DC POWER MODULE 3W Output Specifications Parameter Conditions Output Voltage Accuracy Line Regulation Load Regulation Ripple & Noise Minimum Load Over Voltage Protection Temperature Coefficient Overshoot Min. Vin=Min. to Max. @Full Load Io=0% to 100% 0-20 MHz Bandwidth Zener Diode Clamp --------No minimum Load Requirement ------- Typ. Max. Unit --------- ±2.0 ±1.0 ±1.0 70 %Vom. % % mV P-P 125 ----- 190 ±0.05 5 % of Vo %/℃ %Vout --- %Inom. Max. --------- Unit VAC MΩ KHz ms Hours Foldback, auto-recovery 135 150 (long term overload condition may cause damage) Hiccup mode, indefinite (Automatic Recovery) Current Limitation Short Circuit Protection General Specifications Parameter I/O Isolation Voltage I/O Isolation Resistance Switching Frequency Hold-up Time MTBF (calculated) Protection Class II Conditions 60 Seconds 500 VDC Min. 3000 100 ----- 115VAC, Full Load MIL-HDBK-217F@25℃, Ground Benign Typ. ----65 8 1,200,000 According IEC/EN 60536 UL/cUL 60950-1 recognition(UL certificate) IEC/EN 60950-1(CB-report) IEC/EN 60335-1 recognition(TUV certificata,CB-report) Safety Approvals EMC Specifications Parameter Standards & Level Conduction Radiation EN55014-2 ,EN55024 ESD Radiated immunity Fast transient Surge EMI EMS Conducted immunity PFMF Dips Interruptions Performance EN55011, EN55014-1, EN55022, FCC part 15 Class B EN61000-4-2 Air ± 8kV, Contact ± 4kV EN61000-4-3 10V/m EN61000-4-4 ±2kV EN61000-4-5 ±1kV EN61000-4-6 10Vrms EN61000-4-8 30A/m EN61000-4-11 30% 10ms EN61000-4-11 >95% 5000ms A A A A A A A B Environmental Specifications Parameter Temperature Range (operational) Power Derating Storage Temperature Range Humidity (non condensing) Cooling Lead Temperature (1.5mm from case for 10Sec.) Conditions Ambient +60℃ to +70℃ Min. -25℃ -40℃ --Natural Convection --- Max. +70℃ 0.15 W/℃ +85℃ 95 % rel. H 260℃ Notes 1 2 3 4 5 6 Peak load lasting <30s with a maximum duty cycle of 10%, average output power not to exceed maximum power. All specifications typical at Ta=+25℃, resistive load, 115VAC, 60Hz input voltage and after warm-up time rated output current unless otherwise noted. We recommend to protect the converter by a slow blow fuse in the input supply line. Other input and output voltage may be available, please contact factory. That “natural convection” is about 20LFM but is not equal to still air (0 LFM). Specifications are subject to change without notice. E-mail:[email protected] 2015/05/22 REV:5 Tel:886-6-2923150 Page 2 of 3 AAF-03 SERIES AC/DC POWER MODULE 3W Package Specifications Mechanical Dimensions Pin Connections 25.4 [1.00] 10.16 [0.40] 2 1 5 1 AC (N) 2 AC (L) 3 NC 4 -Vout 5 +Vout NC: No Connection ►All dimensions in mm ►Tolerance: ±0.5 2.54 [0.10] 5.08 [0.20] 4 25.4 [1.00] 25.4 [1.00] 10.16 [0.40] 3 16 .3 [0.64] Function 0.60 [ 0.02] 5.08 [0.20] 20.32 [0.80] 2.54 [0.10] Pin ►Pin (inches) (±0.01) diameter 0.6 ±0.1 (0.02±0.004) Physical Characteristics Case Size : 25.4x25.4x16.3mm (1.0x1.0x0.64 inches) Case Material : Plastic resin (flammability to UL 94V-0 rated) Pin Material Weight : : Copper Alloy with Gold Plate Over Nickel Subplate 17.4g Minmax Technology Co., Ltd. 18, Sin Sin Road, An-Ping Industrial District, Tainan 702, Taiwan Tel: 886-6-2923150 Fax: 886-6-2923149 E-mail: [email protected] 2015/05/22 REV:5 Page 3 of 3