2015-3장 2015.1.20 03:36 PM 페이지68 태산아이인쇄그룹(국) 2261-2488 2400DPI 175LPI SURFACE MOUNT ALUMINUM ELECTROLYTIC CAPACITORS ZC Height 5.5mmL, Low Impedance Series Low Impedance Solvent Proof ・Chip type, low impedance temperature range up to 105° C ・Designed for surface mounting on high density PC board ・Applicable to automatic insertion machine using carrier tape ・Complied to the RoHS directive Item Characteristics Operating temperature range Leakage current max. Capacitance tolerance -55 ~ +105° C I = 0.01CV or 3μ A whichever is greater (after 2 minutes) ±20% at 120Hz, 20° C WV tanδ Dissipation factor max. (at 120Hz, 20° C) 6.3 0.22 WV Z-25° C/Z+20° C Z-55° C/Z+20° C Low temperature characteristics (Impedance ratio at 120Hz) 10 0.19 6.3 2 4 10 2 4 25 0.14 16 2 3 35 0.12 35 3 3 25 2 3 Less than specified value Within ±20% of initial value Less than 200% of specified value Leakage current Capacitance change tanδ Load life (after application of the rated voltage for 1000 hours at 105° C) 16 0.16 After 1000 hours no load test, leakage current, capacitance and tanδare same as load life value. The measurement shall be performed at 20° C by the KS C IEC 60384 - 4 Shelf life (at 105° C) The following specifications shall be satisfied when the capacitors are restored to 20° C after exposing them at 250° C for 10 seconds. Less than specified value Within ±10% of initial value Less than specified value Leakage current Capacitance change tanδ Resistance to soldering heat Unit : mm ● DRAWING (See page 55) -Series code of ZC is “Z” ● DIMENSIONS & MAXIMUM PERMISSIBLE RIPPLE CURRENT WV μF 1.0 1.5 2.2 3.3 4.7 6.8 10 15 22 33 47 68 100 6.3 4×5.3 5×5.3 5×5.3 6.3×5.3 6.3×5.3 5.0 2.6 2.6 1.3 1.3 10 50 80 80 115 115 5×5.3 5×5.3 6.3×5.3 6.3×5.3 2.6 2.6 1.3 1.3 16 80 80 115 115 4×5.3 5×5.3 5×5.3 6.3×5.3 6.3×5.3 25 5.0 2.6 2.6 1.3 1.3 50 80 80 115 115 4×5.3 4×5.3 5×5.3 6.3×5.3 6.3×5.3 6.3×5.3 35 5.0 5.0 2.6 1.3 1.3 1.3 50 50 80 75 115 115 4×5.3 4×5.3 4×5.3 4×5.3 4×5.3 5×5.3 5×5.3 6.3×5.3 6.3×5.3 5.0 5.0 5.0 5.0 5.0 2.6 2.6 1.3 1.3 Ripple current (mA rms) at 105° C, 100kHz Impedance (Ω) at 20° C, 100kHz Case size ØD×L(mm) ● FREQUENCY COEFFICIENT OF PERMISSIBLE RIPPLE CURRENT 68 50 50 50 50 50 80 80 115 115 Frequency 50Hz 120Hz 300Hz 1kHz 10kHz≦ Coefficient 0.35 0.5 0.64 0.83 1.00