SAMTEC CABLE BANDWIDTH PERFORMANCE SELECTOR Single-Ended High Speed Coax CABLE 7dB SERIES PITCH LENGTH INSERTION LOSS POINT 6QCD EQCD EQRD EQRF ERCD FCF8 FFTP HLCD 0,635 mm 0,80 mm 0,80 mm 0,80 mm 0,80 mm 0,80 mm 0,50 mm 0,50 mm 6” 3.34 GHz 9” 3.52 GHz CABLE 7dB SERIES PITCH LENGTH INSERTION LOSS POINT HQCD 0,50 mm 6” 6.08 GHz 9” 6.41 GHz 12” 3.15 GHz 12” 5.25 GHz 19.68” 2.34 GHz 19.68” 4.47 GHz 29.53” 1.44 GHz 29.53” 2.52 GHz 39.37” 1.16 GHz 39.38” 1.71 GHz 6” 5.61 GHz 6” 3.51 GHz 9” 5.31 GHz 9” 3.63 GHz MICD 0,635 mm 12” 5.01 GHz 12” 3.45 GHz 19.68” 4.11 GHz 19.68” 4.47 GHz 29.53” 3.06 GHz 29.53” 2.52 GHz 39.37” 1.92 GHz 39.37” 2.08 GHz 6” 4.32 GHz 6” 7.92 GHz SEAC 1,27 mm 9” 3.87 GHz 9” 7.94 GHz 12” 3.72 GHz 12” 7.99 GHz 19.68” 3.03 GHz 19.68” 6.00 GHz 29.53” 2.67 GHz 29.53” 4.29 GHz 39.37” 2.04 GHz 39.37” 3.29 GHz 152 mm 4.62 GHz 6” 7.23 GHz 305 mm 4.59 GHz 9” 7.20 GHz 500 mm 4.53 GHz 12” 6.46 GHz 1000 mm 4.47 GHz 19.68” 5.79 GHz 6” 6.37 GHz 29.53” 3.26 GHz 9” 6.32 GHz 39.37” 2.12 GHz 9.84” 6.00 GHz 12” 5.43 GHz 19.68” 4.29 GHz 29.53” 2.19 GHz 39.37” 2.50 GHz 6” 7.21 GHz 9” 6.65 GHz 12” 6.37 GHz 19.68” 4.73 GHz 29.53” 2.30 GHz 39.37” 1.46 GHz 3.85” 2.00 GHz 8.84” 1.94 GHz 9.80” 8.00 GHz SQCD 0,635 mm The information contained in this chart does not represent the potential maximum performance of the interconnect system. If your application appears to exceed the cable assembly’s rating from the chart, the cable assembly solution may still work. Please contact our Signal Integrity Group at [email protected] for additional support. The data reflects the point where an insertion loss of 7dB occurs within the cable assembly. The data is based from a test circuit with a characteristic impedance of 50 ohm single-ended and a wiring pattern of Q-S-Q (where Q = quiet line terminated to Zc; S - active single line) within the pin field of the connector. Resonances in the loss data which may be caused by impedance mismatches at the ends of the cable assemblies are not included in the loss calculations. For more information on any of the products included in this chart, click on the series name in the Key to get complete testing information, visit our website at www.samtec.com, or contact our High Speed Cable Group at [email protected]. + DOES NOT INCLUDE TEST BOARD EFFECTS 7 Revised: September 24, 2014 ©Samtec, Inc.