PD43-03 v 1.0 11.11.2013 Description PD43-03 is fabricated from narrow band-gap InAsSb-based heterostructures lattice matched to InAs substrate. The photodiode chip has a photosensitive area of Ø 300 µm and is disposed inside a TO-18 package. The PD is specified with a maximum sensitivity wavelength of 3.6 – 4.1 µm and a cut-off at 4.8 µm. Maximum Ratings Parameter Operating Temperature Storage Temperature Lead Solder Temperature * Values Symbol Min. TCASE TSTG TSLD Max. - 200 - 200 + 60 + 70 + 230 Unit °C °C °C * must be completed within 5 seconds Photodiode Characteristics Parameter Sensitive Area Diameter Cut-off Wavelength Max. Sensitivity Wavelength (>90%) Reverse Voltage Dark Current (VR=-0.1V) Shunt Resistance (VR=-10mV) Capacitance Sensitivity Detectivity www.roithner-laser.com (TCASE=300K) Symbol D λcut λP VR ID RTH C S D* Min. Values Typ. Max. 300 4.8 3.6 4.1 -0.1 4.0 9 10 15 2000 0.7 8 5*10 0.9 8 8*10 Unit µm µm µm V mA Ω pF A/W 𝑐𝑚 ∙ √𝐻𝑧 ∙ 𝑊 −1 1 Preformance Characteristics Spectral Response (typical) Temperature Shift of Spectral Response Dark Current-Temperature Dependence Resistance-Temperature Dependence Outline Dimensions PD34-03 TO-18, without window All Dimensions in mm www.roithner-laser.com 2 Recommended Modes of Photodiode Operation Photovoltaic Mode Photoconductive Mode We recommend using photovoltaic mode, when PD is used under reverse bias. Use Photoconductive mode (mode with reverse bias) with caution! Precautions Operation: • Check your connection circuits before turning on the PD. • Mind the PD polarity: PD anode is marked with a RED dot. • DO NOT connect the PD to the multimeter. Soldering: • • • • • Do avoid overheating of the PD Do avoid electrostatic discharge (ESD) Do avoid mechanical stress, shock, and vibration Do only use non-corrosive flux Do not apply current to the LED until it has cooled down to room temperature after soldering Static Electricity: PDs are sensitive to electrostatic discharge (ESD). Precautions against ESD must be taken when handling or operating these PDs. Surge voltage or electrostatic discharge can result in complete failure of the device. © All Rights Reserved The above specifications are for reference purpose only and subjected to change without prior notice www.roithner-laser.com 3