5.0SMDJ SERIES SURFACE MOUNT TRANSIENT VOLTAGE SUPPRESSOR VOLTAGE-11 TO 170 Volts 5000 Watt Peak Pulse Power DO-214AB (SMC J-Bend) Cathode Band 0.245 (6.22) 0.220 (5.59) 0.126 (3.20) 0.114 (2.90) 0.280 (7.11) 0.260 (6.60) 0.012 (0.305) 0.006 (0.152) 0.103 (2.62) 0.079 (2.06) 0.008 (0.203) MAX. 0.060 (1.52) 0.030 (0.76) 0.320 (8.13) 0.305 (7.75) FEATURES ◎ For surface mounted applications in order to optimize board space ◎ Low profile package ◎ Built-in strain relief ◎ Glass passivated junction ◎ Low inductance ◎ Excellent clamping capability ◎ Repetition Rate (duty cycle):0.01% ◎ Fast response time: typically less than 1.0ps from 0 Volts to BV for unidirectional types ◎ Typical IR less than 1μA ◎ High temperature soldering: 250°C/10 seconds at terminals Dimensions in inches and(millimeters) Dimensions in inches and (millimeters) MECHANICAL DATA Case: JEDEC DO214AB. Molded plastic over glass passivated junction Terminal: Solder plated, solderable per MIL-STD-750, Method 2026 Polarity: Standard Packaging: 16mm tape (EIA STD RS-481) Weight: 0.007 ounce, 0.21 gram MAXIMUM RATINGS AND CHARACTERISTICS Ratings at 25℃ ambient temperature unless otherwise specified. RATING Peak Pulse Power Dissipation on 10/1000μs waveform (Note 1,2 ,FIG.1) SYMBOL VALUE Minimu PPPM m 5000 SEE UNITS Watts Peak Pulse Current of on 10/1000μs waveform (Note 1,FIG.3) IPPM TABLE Amps Peak Forward Surge Current,8.3ms Single Half Sine-Wave Superimposed on Rated Load,(JEDEC Method) (Note2, 3) IFSM 300 Amps TJ , TSTG -55 to + 150 ℃ Operating junction and Storage Temperature Range 1 Notes : 1.Non-repetitive current pulse , per Fig. 3 and derated above TA = 25℃ per Fig. 2 . 2.Mounted on 8.0mm x 8.0mm Copper Pads to each terminal 3.8.3ms single half sine-wave , or equivalent square wave, Duty cycle = 4 pulses per minutes maximum. page1 www.umsemi.com.tw 5.0SMDJ SERIES SURFACE MOUNT TRANSIENT VOLTAGE SUPPRESSOR VOLTAGE - 20 TO 170 Volts 5000Watts Peak Pulse Power 5.0SMDJ PART NUMBER DEVICE MARKING REVERSE BREAKDOWN BREAKDOWN TEST VOLTAGE VOLTAGE STAND- OFF CODE CURRENT IT VBR(V) VBR(V) VOLTAGE (mA) VRWM(V) MIN.@IT MAX.@IT Uni-polar Bi-polar 5BEN 11.0 12.20 13.50 5.0SMDJ 11A-CA 5PEN 5BEP 12.0 13.30 14.70 5.0SMDJ 12A-CA 5PEP 5BEQ 13.0 14.40 15.90 5.0SMDJ 13A-CA 5PEQ 5BER 14.0 15.60 17.20 5.0SMDJ 14A-CA 5PER 5BES 15.0 16.70 18.50 5.0SMDJ 15A-CA 5PES 5BET 16.0 17.80 19.70 5.0SMDJ 16A-CA 5PET 5BEU 17.0 18.90 20.90 5.0SMDJ 17A-CA 5PEU 5BEV 18.0 20.00 22.10 5.0SMDJ 18A-CA 5PEV 5BEW 20.0 22.20 24.50 5.0SMDJ 20A-CA 5PEW 5BEX 22.0 24.40 26.90 5.0SMDJ 22A-CA 5PEX 5BEZ 24.0 26.70 29.50 5.0SMDJ 24A-CA 5PEZ 5BFE 26.0 28.90 31.90 5.0SMDJ 26A-CA 5PFE 5BFG 28.0 31.10 34.40 5.0SMDJ 28A-CA 5PFG 5BFK 30.0 33.30 36.80 5.0SMDJ 30A-CA 5PFK 5BFM 33.0 36.70 40.60 5.0SMDJ 33A-CA 5PFM 5BFP 36.0 40.00 44.20 5.0SMDJ 36A-CA 5PFP 5BFR 40.0 44.40 49.10 5.0SMDJ 40A-CA 5PFR 5BFT 43.0 47.80 52.80 5.0SMDJ 43A-CA 5PFT 5BFV 45.0 50.00 55.30 5.0SMDJ 45A-CA 5PFV 5PFX 48.0 53.30 58.90 5.0SMDJ 48A 5PFZ 51.0 56.70 62.70 5.0SMDJ 51A 5RGE 54.0 60.00 66.30 5.0SMDJ 54A 5PGG 58.0 64.40 71.20 5.0SMDJ 58A 5PGK 60.0 66.70 73.70 5.0SMDJ 60A 5PGM 64.0 71.10 78.60 5.0SMDJ 64A 5PGP 70.0 77.80 86.00 5.0SMDJ 70A 5PGR 75.0 83.30 92.10 5.0SMDJ 75A 5PGT 78.0 86.70 95.80 5.0SMDJ 78A 5PGV 85.0 94.40 104.00 5.0SMDJ 85A 5PGX 90.0 100.00 111.00 5.0SMDJ 90A 5PGZ 100.0 111.00 123.00 5.0SMDJ 100A 5PHE 110.0 122.00 135.00 5.0SMDJ 110A 5PHG 120.0 133.00 147.00 5.0SMDJ 120A 5PHK 130.0 144.00 159.00 5.0SMDJ 130A 5PHM 150.0 167.00 185.00 5.0SMDJ 150A 5PHP 160.0 178.00 197.00 5.0SMDJ 160A 5PHR 170.0 189.00 209.00 5.0SMDJ 170A For Bidirectional type having Vrwm of 20 volts and less,the Ir limit is double. page2 www.umsemi.com.tw 10 10 10 10 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 MAXIMUM PEAK REVERSE CLAMPING PULSE LEAKAGE @ VOLTAGE CURRENT VRWM IR(µA) @Ipp Ipp (A) Vc(V) 18.2 19.9 21.5 23.2 24.4 26.0 27.6 29.2 32.4 35.5 38.9 42.1 45.4 48.4 53.3 58.1 64.5 69.4 72.7 77.4 82.4 87.1 93.6 96.8 103.0 113.0 121.0 126.0 137.0 146.0 162.0 177.0 193.0 209.0 243.0 259.0 275.0 275.00 252.00 233.00 216.00 205.00 193.00 181.00 172.00 155.00 141.00 129.00 119.00 110.00 103.00 93.90 86.10 77.60 72.10 68.80 64.70 60.70 57.50 53.50 51.70 48.60 44.30 41.40 39.70 36.50 34.30 30.90 28.30 26.00 24.00 20.60 19.30 18.20 800 800 500 200 100 50 20 10 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5.0SMDJ SERIES RATINGS AND CHARACTERISTIC CURVES Ratings and Characteristic Curves(TA=25℃ unless otherwise noted) Fig. 1 - Peak Pulse Power Rating Curve Fig.2 - Pulse Derating Curve 100 Non-repetitive pulse waveform shown in Fig.3 TA = 25°C 87.5 Peak Pulse Power (PPP) or Current (IPP) Derating in Percentage,% PPPM-Peak Pulse Power (kW) 100 10 1 75 62.5 50 37.5 25 12.5 0.1 0 0.1µs 1.0µs 10µs 100µs 1.0ms 10ms 0 25 50 td - Pulse Width (sec.) Fig.3 - Pulse Waveform TJ = 25°C Pulse Width(td)is defined as the point where the peak current decays to 50% of IPPM Peak Value IPPM 100 100 10/1000µsec.Waveform as defined by R.E.A. 150 175 200 VR = 0 1000 VR = Rated Stand-off 100 f = 1MHz Vsig = 50mVp-p TJ = 25°C td 0 1.0 0 2.0 3.0 3.0 4.0 10 4.0 10 1 10 10 5 Fig. 5 - Steady State Power Derating Curve 500 1000 Fig.6 - Maximum Non-repetitive Forward Surge current 8.0 300 IFSM,Peak Forward Surge Currnet (A) 60Hz Resistive or Inductive Load 7.0 6.0 5.0 4.0 3.0 2.0 1.0 0 100 VWM - Reverse Stand-Off Voltage (V) t - Time(ms) PM(AV),Steady State Power Dissipation (W) 125 Unidirectional Bidirectional 1000 Half Value- IPPM 2 50 100 Fig. 4 - Typical Junction Capacitance 10000 10000 CJ - Capacitance (pF) IPPM - Peak Pulse Current,% IRSM 150 tr = 10µsec. 75 TA - Ambient Temperature (° C) 8.3ms Single Half Sine-Wave (JEDEC Method) 250 200 150 100 0 25 50 75 100 125 150 175 200 1 10 Number of Cycles at 60 HZ TL - Lead Temperature (°C) page3 www.umsemi.com.tw 100