WPANT65010-R1A GPS L1 Band Active Patch Module Description / Application This is a 10mm X 10mm Active Patch Module for GPS L1 Band frequencies. This can be used in portable navigation & tracking applications. The module consists of a circularly polarized patch antenna and a single stage Low Noise Amplifier (LNA). It comes with a U.FL cable and an IPX / Hirose equivalent connector. We can assist your engineers to optimize mounting positions for these antennas in your specific application and can further customize the antennas for your specific needs. Please contact [email protected] with your specific application requirements. Electrical Properties Operating Frequency Approximate Antenna Impedance [Ω] LNA Gain [dBi] (Typical) Active Antenna Peak Gain [dBi] Voltage [V] (Typical) Current [mA] (Typical) 1567 – 1583 MHz 50Ω 24 dBi 21 dBi @ Zenith 3 ± 0.5 V 13 mA @ 3V Noise Figure [dB] (Typical) 1.8 dB Polarization RHCP Axial Ratio [dB] (Typical) 3 dB Mechanical / Environmental Properties Patch Dimensions Module Dimensions Cable Connector Operating / Storage Temperature Environmental Hazardous Materials Rev: 2.0 Created on: March 27, 2014 10.8mm X 10.8mm X 4mm 10.8mm X 10.8mm X 6.5mm 100mm long 1.13mm OD Micro Co-ax IPX / Hirose equivalent o o -40 C to +90 C IP67 rated; Meets standards for UL 94V-0 RoHS Compliant Created by: MKS Approved by: BP Page | 1 Pictures of the Antenna Rev: 2.0 Created on: March 27, 2014 Created by: MKS Approved by: BP Page | 2