WPANT10022-C2D 915 MHz PIFA Antenna Description / Application This stamped metal PIFA Antenna can be installed inside any wireless device. It is a surface independent antenna, in the sense it will work the same whether it is installed on a metallic or a non-metallic surface. It comes with a 3.15’’ long standard 1.32mm OD Micro Co-ax cable and IPX / Hirose equivalent connector. We can assist your engineers to optimize mounting positions for these antennas in your specific application and can further assist to trouble shoot system integration issues such as TRP/TIS and FCC requirements. We specialize in developing customized Antenna solutions. Please contact [email protected] with your specific application requirements. Electrical Properties Operating Frequency Approximate Antenna Impedance [] VSWR – Typical 900 – 930 MHz 50Ω < 2:1 Peak Gain [dBi] (Typical) Device and Application dependent Efficiency [%] (Typical) Device and Application dependent Polarization Pattern Linear Omni-directional Note: The above mentioned performance metrics were recorded with the antenna embedded inside the client’s device. Mechanical / Environmental Properties Antenna Dimensions Antenna Color Cable Connector Operating / Storage Temperature Environmental Hazardous Materials Rev: 3.0 Created on: February 21, 2014 1.9’’ X 1.8’’ X 0.6’’ Silver (47.75mm X 46.5mm X 14.5mm) 3.15’’ long 1.32mm OD Micro Co-ax IPX / Hirose equivalent o o -40 C to +90 C Meets standards for UL 94V-0 RoHS Compliant Created by: MKS Approved by: BP Page | 1 Pictures of the Antenna (3D Drawing) Rev: 3.0 Created on: February 21, 2014 Created by: MKS Approved by: BP Page | 2 VSWR of the Antenna Rev: 3.0 Created on: February 21, 2014 Created by: MKS Approved by: BP Page | 3