NS-10/PL2-S Dual Axis Inclinometer The NS-10/PL2-S is a dual axis, OEM Inclinometer utilizing two single axis, tilt sensors which work on the conductivity principle. The electronics measure the electrical stray field that is formed by applying AC voltage to planar electrode structures that are immersed in electrolytic fluid. When the sensor is tilted, the fluid level changes over the measuring electrodes; and, as a result, the conductivity with respect to the stray field changes. Using a differential measurement principle, the tilt angle and the tilt direction can be measured . All PL type inclinometers are microprocessor controlled transducers capable of producing a linearized and temperature compensated RS-232 digital output. 1,50 cm 4,50 cm 1 6 Applications • • • • • Zero point detection Alignment and level control Angle measurement Wheel Alignment Load cell compensation Pin out Connector: 1 NS-10/PL2-S 6 1 Vcc + 6,5 VDC ... + 24 VDC 2 RxD RS 232 3 GND 4 N.C. 5 N.C. 6 TxD Advantages • • RS 232 • • • Single and dual axis models Microprocessor controlled inclinometer Integrated linearisation and temperature compensation Digital output at RS 232 interface Small constrution kit Specification Conditions Measurement range Resolution Precision (absolute) Precision (absolute) Noise (RMS) Rise time RS 232 interface 2 Baud rate Transmission rate Supply voltage Current consumption Operating temperature Storage temperature Weight Dimensions T1=0…+55°C T2=-25…+85°C 1 RT 0° 10°,t=90% ±10V Min -10 -0,15 -0,3 3 3,5 +6,5 20 -25 -40 Typ 0,001 0,03 2,5 5 9600 4 25 21 45 x 45 x 17 Max +10 +0,15 +0,3 7 4,5 +24 30 +85 +85 Units ° ° 3 ° of FS,T1 3 ° of FS,T2 ° s k Bits/s Hz VDC mA °C °C g mm 1 RT = by room temperature 20°C Baud rate = fixed FS= Full scale 2 3 Conector: Compeny Molex Picoflex PF-50 1,27mm HL-Planartechnik GmbH Hauert 13, D - 44 227 Dortmund, Tel.: +49 (0) 231/97400, Fax.: +49 (0) 231/974020 Internet: http://www.hlplanar.com E-Mail: [email protected] Stand: 16.01.03 Design: Zn