Tfs160b - Vectron International

Tfs160b.doc
version 1.3
VI TELEFILTER
Filter Specification
16.05.2002
TFS 160B
1/5
Measurement condition
Ambient temperature:
23 °C
Input power level:
0 dBm
Terminating impedance *
Input
660 Ω || -1.6 pF
Output
660 Ω || -1.6 pF
Characteristics
Remark:
Reference level for the relative attenuation arel of the TFS 160 B is the insertion loss. The insertion loss ae is defined as the minimum of
attenuation in pass band. The centre frequency fc is the arithmetic mean value of the upper and lower frequencies at the 3 dB filter attenuation level
relative to the insertion loss ae. The nominal frequency fN is fixed at 160,620 MHz without any tolerance. The given values for the relative
attenuation arel and for the group delay ripple have to be reached at the frequencies given below also if the centre frequency fc is shifted due to the
temperature coefficient of frequency TCf in the operating temperature range and due to a production tolerance for the centre frequency fc.
Data
typ. value
tolerance/limit
Insertion loss
(Reference level)
ae
3
Nominal frequency
fN
-
Centre frequency
fC
160,624 MHz
-
3 dB – bandwidth
BW
100
kHz
-
Relative attenuation
fN + 910
kHz
arel
65
dB
Usable signal bandwidth
dB
max.
5
dB
160,620 MHz
-
min
60
dB
min.
fN ±10
kHz
Operating temperature range
- 20 °C ... + 70 °C
Storage temperature range
- 30 °C ... + 85 °C
Temperature coefficient of frequency
Frequency inversion temperature T0
TCf**
-0,036
ppm/K²
+ 25
°C
*) The terminating impedances depend on parasitics and q-values of matching elements and the board used, and are to be understood as
reference values only. Should there be additional questions do not hesitate to ask for an application note or contact our design team.
**) ∆f(Hz) = TCf(ppm/K²) x (T-T0)² x fTo(MHz)
Generated:
Checked / approved:
VI TELEFILTER
Vectron International, Inc.
Potsdamer Straße 18
267 Lowell Road
D 14 513 TELTOW / Germany
Hudson, NH 03051 / USA
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
Tel: (603) 598-0070 Fax: (603) 598-0075
E-Mail: [email protected]
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Tfs160b.doc
version 1.3
VI TELEFILTER
Filter Specification
16.05.2002
TFS 160B
2/5
Construction and pin configuration
(All dimensions in mm)
Pin 2
Input
Pin 7
Output
Pin 1,3,4,5,6,8,9,10 Ground
TFS160B
P23
Date code
Datecode:
M
N
P
...
1
2
Year + week
2000
2001
2002
3
10
4
9
5
8
7
6
50 Ω matching network 1
L1
L2
7
2
Input
50 Ohm
Output
50 Ohm
SAW
C1
C2
1,3,4,5,6,8,9,10
50 Ω matching network 2
7
2
Input
50 Ohm
SAW
C1
L1
C2
Output
50 Ohm
L2
1,3,4,5,6,8,9,10
Note: The filter operates in the matching network in the same manner if the filter is inserted with a rotation of 180 °.
VI TELEFILTER
Vectron International, Inc.
Potsdamer Straße 18
267 Lowell Road
D 14 513 TELTOW / Germany
Hudson, NH 03051 / USA
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
Tel: (603) 598-0070 Fax: (603) 598-0075
E-Mail: [email protected]
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Tfs160b.doc
version 1.3
VI TELEFILTER
16.05.2002
Filter Specification
TFS 160B
3/5
Stability characteristics
After the following tests the filter shall meet the whole specification:
1. Shock:
500g, 18 ms, half sine wave, 3 shocks each plane;
DIN IEC 68 T2 - 27
2. Vibration:
10 Hz to 500 Hz, 0,35 mm or 5g respectively, 1 octave per min, 10 cycles per plan, 3 plans;
DIN IEC 68 T2 - 6
3. Change of
temperature:
-55 °C to 125°C / 30 min. each / 10 cycles
DIN IEC 68 part 2 – 14 Test N
4. Resistance to
solder heat (reflow):
reflow possible: twice max.;
for temperature conditions refer to the attached "Air reflow temperature conditions" on page 4;
Packing:
Tape & Reel:
IEC 286 - 3, with exception of value for N and minimum bending radius;
tape type II, embossed carrier tape with top cover tape on the upper side;
max. pieces of filters per reel:
reel of empty components at start:
reel of empty components at start including leader:
trailer
2000
min 300 mm
min 500 mm
min 300 mm
Tape (all dimensions in mm)
EMBOSSED CARRIER TAPE
W
Po
Do
:
:
:
16
± 0,3
4
± 0,1
1,5 + 0,1
E
F
:
:
1,75 ± 0,1
7,5 ± 0,1
G (min) :
P2
:
0,6
2 ± 0,1
P1
:
12
D1(min) :
Ao
:
1,5
7,6
Bo
CT
9,6 ± 0,1
13,5 ± 0,1
:
:
Do
Po
P2
E
Ao
F
D1
CT
W
Bo
± 0,1
G
± 0,1
P1
COVER TAPE
W 2
Reel (all dimensions in mm):
A
:
W1
:
W2 (max) :
330
16,4 +2
22,4
N (min)
:
60
C
:
12,8 ± 0,1
A
C
N
W 1
The minimum bending radius is 45 mm. The mounting surface of the filters faces the bottom side of the embossed carrier tape.
Markings on the filters can be read if the upper side of the carrier tape is regarded with the sprocket holes on its right.
VI TELEFILTER
Vectron International, Inc.
Potsdamer Straße 18
267 Lowell Road
D 14 513 TELTOW / Germany
Hudson, NH 03051 / USA
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
Tel: (603) 598-0070 Fax: (603) 598-0075
E-Mail: [email protected]
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Tfs160b.doc
version 1.3
VI TELEFILTER
16.05.2002
Filter Specification
TFS 160B
4/5
Air reflow temperature conditions
1st and 2nd air reflow profile
Name:
Temperature:
Time:
pre-heating periods
150 °C - 170 °C
60 sec. - 90 sec.
main-heating periods
over 200 °C
20 sec. - 25 sec.
peak temperature
255 °C ± 5 °C
Chip-mount air reflow profile
260
240
220
200
temperature / °C
180
160
140
120
100
80
60
40
20
0
0
20
40
60
80
100
120
140
160
180
200
220
240
time / sec.
Table for temperature vs. time during the air reflow process
Tolerance of temperatures: ± 5 °C
time / sec.
0
10
20
30
40
50
60
70
80
90
100
110
120
130
temperature / °C
23
34
46
60
80
103
121
134
143
150
154
156
158
159
time / sec.
140
150
160
170
180
190
195
200
205
210
215
220
230
240
temperature / °C
160
161
164
170
180
205
230
255
230
205
180
165
140
120
VI TELEFILTER
Vectron International, Inc.
Potsdamer Straße 18
267 Lowell Road
D 14 513 TELTOW / Germany
Hudson, NH 03051 / USA
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
Tel: (603) 598-0070 Fax: (603) 598-0075
E-Mail: [email protected]
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Tfs160b.doc
version 1.3
VI TELEFILTER
Filter Specification
16.05.2002
TFS 160B
5/5
History
Version
Reason of Changes
Name
Date
1.1
Generate Filter specification in actually format.
Add “History”.
Herrler
24.07.2001
1.2
Correct typo in relative attenuation.
Correct reel information.
Change matching network.
Add typical value for centre frequency.
Correct marking.
Dr. Wall
28.01.2002
1.3
Correct package drawing.
Dr. Wall
16.05.2002
VI TELEFILTER
Vectron International, Inc.
Potsdamer Straße 18
267 Lowell Road
D 14 513 TELTOW / Germany
Hudson, NH 03051 / USA
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
Tel: (603) 598-0070 Fax: (603) 598-0075
E-Mail: [email protected]
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.