FSHPLC Flow switch for connection to PLC Signal level output for PLC 20 l/min turn on flow rate Automatic shut down on flow stop Volt free contact for output to PLC 1”BSP pipe connections Technical Specification Screw mount Material Enclosure material Enclosure rating Start up flow rate Max Pressure Max Temperature Pipe connections Q. min P max T max l/min bar °C BSP Electrical Specification Output Max voltage Switching Current Max Vac mA Standard Parts FSH10PLC On flow rate 20 l/min Brass Polyamide IP54 20 10 100 1” SPNO volt free contact <5 <1 The FSHPLC can be used to control some other equipment or process via a PLC. It could be for controlling a circulating or centrifugal electric pump that is providing increased pressure or flow within water systems with storage tanks. 95 The FSHPLC switches the output, once the flow rate through the pipe exceeds 20 l/min. A flow of less than 20 l/min, whether due to a lack of supply (e.g. tank empty) or to a decrease in demand(e.g. tap closing), will turn the output off again. 94 22 113 Cynergy3 Components Ltd. 7 Cobham Road Ferndown Industrial Estate Wimborne, Dorset BH21 7PE Telephone +44 (0) 1202 897969 Email:[email protected] ISO9001 C E R T I F I E D www.cynergy3.com © 2012 Cynergy3 Components, All Rights Reserved. Specifications are subject to change without prior notice. Cynergy3 Components and the Cynergy3 Components logo are trademarks of Cynergy3 Components Limited. FSHPLC Flow switch for connection to PLC Installation information The flow switch is designed to be used in a horizontal pipe with the switch mounted through a side entry. Pipe connection is G1” (1”BSP). The device relies on the flow of liquid working in opposition to the spring loaded paddle. The liquid flow moves the paddle within the pipe, when the flow increases beyond the minimum specified level. A magnet mounted on the head of the paddle closes a magnetic switch in the control circuit. The output switch will open, if the flow drops below the specified level and the paddle has returned to the rest position. G1” socket connection Flow Direction The output is a SPNO switch with contacts rated to 1mA/5Vac. G1” - G4” pipe size G1” mounting thread “o” ring seal Adaptor ring “o” ring seal Cynergy3 Components Ltd. 7 Cobham Road Ferndown Industrial Estate Wimborne, Dorset BH21 7PE Telephone +44 (0) 1202 897969 Email:[email protected] ISO9001 C E R T I F I E D www.cynergy3.com © 2012 Cynergy3 Components, All Rights Reserved. Specifications are subject to change without prior notice. Cynergy3 Components and the Cynergy3 Components logo are trademarks of Cynergy3 Components Limited.