FMAC SINE DCL 3-Phase AC Filters / DC Filters www.schurter.com/PG80 Sine wave output filter with a voltage dc link Description -Design corresponding to UL 1283, CSA 22.2 No. 8, IEC/EN60939 -Enhancement of the system efficiency Applications -Optimized for long motor cables (up to 1000 m) and operation under full load -Equipped with voltage connection to converter dc link circuit for best results -Frequency converters in uninterruptible power supplies, elevators, heating-, ventilating- and air conditioning-systems, traction and conveyer systems -Cost saving technologie, increase of motor life time, deployment of flexible lightweight unshielded instead of expensive shielded motor cables, reduced fitting work Weblinks pdf-datasheet, html-datasheet, General Product Information, Approvals, CE declaration of conformity, RoHS, CHINA-RoHS, REACH, e-Shop, SCHURTER-Stock-Check, Distributor-Stock-Check, Detailed request for product Technical Data Rated Current Rated voltage Approval for Overload Current Dielectric Strength Weight Material: Housing Sealing Compound 4 - 16 A @ Ta 40 °C 500/288 VAC; 50/60 Hz 4 - 16 A @ Ta °C / 500/288 VAC; 50 Hz 1.5 x Ir for 1 minute, per hour 500/288 VAC: 1.1 kVDC between L-L 2.5 kVDC between L-PE Test voltage (2 sec) 16 - 24 kg Metal UL 94V-2 Mounting Terminal Operating Temperature [°C] Climatic Category Degree of Protection Protection Class Screw-on mounting on chassis, from top Screw clamps -25 °C to 100 °C 25/100/21 acc. to IEC 60068-1 IP 20 acc. to IEC 60529 Suitable for appliances with protection class I acc. to IEC 61140 EMC Products 1 FMAC SINE DCL 3-Phase AC Filters / DC Filters www.schurter.com/PG80 Dimension Case 2G max. 350 (19) (23) (28) max. 90 34 730±10 30 20 ±5 70 ±5 max. 150 (109.5) 100±5 3) (2x) (112) M6x14; 3-4 Nm max. 390 0 4) (7x) (4x) 1.5 mm 2 (7x) 6.5 ±0.3 (4x) 5) 370 –2 (11) 8) M4x16; 1.5-2 Nm 44 ±0.3 4mm 2 ; 0.5-0,6 Nm 1) 6) (2x) 2) 7) (3x) 1.5 mm 2 1) Inverter 2) Motor 3) Shield 4) Shielded cable 5) Endsleeves 6) Ground 7) Shieldes cable 8) Operation Mode Case IB max. 350 (19) (23) (28) max. 90 34 730±10 70 ±5 30 20 ±5 M6x14; 3-4 Nm max. 180 (139.5) 3) (2x) (142) 100±5 max. 390 0 M4x16; 1.5-2 Nm 4mm 2 ; 0.5-0,6 Nm 1) 6) (2x) 7) (3x) 1.5 mm 2 1) Inverter 2) Motor 3) Shield 4) Shielded cable 5) Endsleeves 6) Ground 7) Shieldes cable 8) Operation Mode 2 EMC Products 2) 8.6 ±0.3 (4x) 8) 44 ±0.3 5) (7x) 370 –2 4) (4x) 1.5 mm 2 (11) (7x) FMAC SINE DCL 3-Phase AC Filters / DC Filters www.schurter.com/PG80 Case 2H max. 350 (19) (23) (28) max. 90 34 730±10 30 20 ±5 70 ±5 M6x14; 3-4 Nm (174.5) max. 215 3) (2x) (177) 100±5 max. 390 0 4) (7x) (4x) 1.5 mm 2 (7x) 8.7 ±0.3 (4x) 5) 370 –2 (11) 8) M4x16; 1.5-2 Nm 44 ±0.3 4mm 2 ; 0.5-0,6 Nm 1) 6) (2x) 2) 7) (3x) 1.5 mm 2 1) Inverter 2) Motor 3) Shield 4) Shielded cable 5) Endsleeves 6) Ground 7) Shieldes cable 8) Operation Mode Case 2I max. 310 (38) (23) (45) max. 140 40 730±10 70 ±5 55 20 ±5 (15) M6x14; 3-4 Nm (180) max. 230 3) (2x) (180) 100±5 max. 350 0 (11) (7x) 4) (4x) 2.5 mm 2 M4x16; 1.5-2 Nm 8) 10mm2 ; 1.5-1.8 Nm 1) 6) (2x) 2) 95 ±0.3 5) (7x) 8.7 ±0.3 (4x) 330 –2 7) (3x) 2.5 mm 2 1) Inverter 2) Motor 3) Shield 4) Shielded cable 5) Endsleeves 6) Ground 7) Shieldes cable 8) Operation Mode EMC Products 3 FMAC SINE DCL 3-Phase AC Filters / DC Filters www.schurter.com/PG80 Diagrams A) F1 B) 3 F2 F3 M 3 3 A) B) U U 1) 2) 3) 4) 5) I L1 L2 L3 I PE Note: The inverter switching frequency must lie within the range from 2 to 20kHz. A switching frequency below or above the mentioned range will result in poor performances. Sine wave output filters with dc-link produce leakage currents. These leakage currents could, in combination with certain OEM inverter types, disturb overall system performance, causing a "over current or short to earth" error message on the inverter. For such cases Schurter suggests the following three solutions or a combination of each: 1) Increasing the switching frequency of the inverter (drawback: increased power loss in the inverter) 2) Activating the low leakage sine wave output filter operation mode by removing the factory set detachable screw (drawback: light increase of the leakage current in the motor) 3) Connecting a ground wire choke type DEH in the inverters earth connection (drawback: additional component) 1) Inverter 2) Ground choke 3) DC-Link 4) Sine wave output filter 5) Motor All Variants Rated Current Rated voltage Switching frequency Motor frequency Rated motor power Motor cable lenght DC resistance Total power loss Weight Housing Order Number [A] [VAC] [kHz] [Hz] [kW] [m] [mΩ] [W] [kg] 8 500/288 2...20 0...200 3.0 <= 1000 220 14 16 kg IB FMAC-0SIB-0862 4 500/288 2...20 0...200 1.5 <= 1000 450 8 13 kg 2G FMAC-0S2G-0462 12 500/288 2...20 0...200 5.5 <= 1000 140 20 20 kg 2H FMAC-0S2H-1262 16 500/288 2...20 0...200 7.5 <= 1000 110 28 24 kg 2I FMAC-0S2I-1662 Availability for all products can be searched real-time:http://www.schurter.com/en/Stock-Check/Stock-Check-SCHURTER 1 Pcs 03.09.2015 Packaging unit 4 EMC Products The specifications, descriptions and illustrations indicated in this document are based on current information. All content is subject to modifications and amendments. Information furnished is believed to be accurate and reliable. However, users should independently evaluate the suitability and test each product selected for their own applications.