driven by E910.48 LIN SBC with voltage regulatoR and watchdog Features ÿ ÿ ÿ ÿ ÿ ÿ ÿ ÿ ÿ ÿ ÿ ÿ ÿ ÿ ÿ ÿ General Description meets current OEM hardware requirements Conforming to LIN 1.3, 2.1 and J2602 ESD protection on BUS pin >12kV according to IEC-61000-4-2 Only a few external components needed Wake up via bus with slope detection and debouncing Operating voltage (VS) 4V to 27V Very low standby current (typ. <20µA) Two selectable output voltages: 5V or 3.3V ± 2.0% Stable voltage regulator with bypass capacitance down to 100nF Output current up to 100mA Optional power transistor for VDD possible Selectable watchdog windows: Fixed: 35ms or 75ms; Variable: 3ms to 50ms Reset pulse durations (10ms, 65ms) and programmable threshold levels Output slew rate control to reduce EMI Over temperature and output current protection SOIC 16 package, QFN 5x5 in preparation The E910.48 is a fully integrated LIN interface. Additional functions extend this device to a complete System Basic Chip (SBC) for use together with any µC in an automotive environment. A flexible voltage regulator provides either 3.3V or 5V supply with 100mA current capability. It can be switched on by either a (high voltage tolerant) signal (ENABLE) or by a LIN bus wake-up request. The sense input allows to connect an external load transistor in order to extend the current capability according to the particular application needs. The external Resistor Rs can help to reduce the internal power dissipation without compromising low supply voltage operation. An active low reset signal is generated depending on the integrated, configurable power good detection, according to the watchdog status, and as well as during power on/off cycles. pe Be rf st in orm ESD >1 clas an 2k s ce Applications possible configuration for 5V operation, ÿ Bus interface for Local Interconnect Network (LIN)watchdog cycle time 35ms reset threshold +4,45V / 10ms, V VBAT RS 100nF 100nF VS RESW VS1 VS monitor MOD VDD VDDS Voltage regulator ENABLE 5V ≥100nF WDIN SELWD External µC RESET * WAKE * TXD RXD Watch dog SELRES RESET Reset generation Wakeup detection & VS LIN transceiver to external µC * WAKE to external µC * BUS 220pF E910.48 ELMOS Semiconductor AG Info Sheet QM-No.: 25IS0002E.00 2009-09-29 ELMOS Semiconductor AG – Headquarters Heinrich-Hertz-Str. 1 | 44227 Dortmund | Germany Phone + 49 (0) 231 - 75 49 - 100 | Fax + 49 (0) 231 - 75 49 - 149 [email protected] | www.elmos.de Note ELMOS Semiconductor AG (below ELMOS) reserves the right to make changes to the product contained in this publication without notice. ELMOS assumes no responsibility for the use of any circuits described herein, conveys no licence under any patent or other right, and makes no representation that the circuits are free of patent infringement. While the information in this publication has been checked, no responsibility, however, is assumed for inaccuracies. ELMOS does not recommend the use of any of its products in life support applications where the failure or malfunction of the product can reasonably be expected to cause failure of a life-support system or to significantly affect its safety or effectiveness. Products are not authorized for use in such applications. Copyright © 2009 ELMOS Reproduction, in part or whole, without the prior written consent of ELMOS, is prohibited.