Eon Silicon Solution Inc. Page1/5

Eon Silicon Solution Inc.
Page1/5
EN29LV640T/B VS S29GL064A
64Mb FLASH SPEC COMPARISON
Issued Date :
2007/08/06
Prepared By :
FAE Engineer : Sunny Tai
Approved By :
FAE Manager : Jason Tseng
This Application Note may be revised by subsequent
versions or modifications due to changes in technical
specifications.
Rev. A, Issue Date: 2007/ 08/ 06
©2005 Eon Silicon Solution, Inc., www.essi.com.tw
Eon Silicon Solution Inc.
Page2/5
1. Part No.
Eon :
EN29LV640T/B
Spansion :
S29GL064A
Eon
Spansion
Remark
EN29LV640T
S29GL064AxxxR3
Top Boot
EN29LV640B
S29GL064AxxxR4
Bottom Boot
2. Basic Features:
The following features are identical with each other.
2.1
2.2
2.3
2.4
2.5
2.7 – 3.6 Read/Program/Erase Voltage.
Access Time : as fast as 90 ns
JEDEC standard compatible pin-out and command sets.
Available package : 48-Lead TSOP and FBGA.
boot sector structure:
127 32-Kword (64-Kbyte) sectors + 8 4Kword (8Kbyte) boot sectors
R3 =Top boot sector device, top two address sectors protected when WP#/ACC=VIL
R4 =Bottom boot sector device, bottom two address sectors protected when WP#/ACC=VIL
2.6
Byte/Word Access : x8 and x16 capable
This Application Note may be revised by subsequent
versions or modifications due to changes in technical
specifications.
Rev. A, Issue Date: 2007/ 08/ 06
©2005 Eon Silicon Solution, Inc., www.essi.com.tw
Eon Silicon Solution Inc.
Page3/5
3. Differences
3.1 Secured Silicon Sector 128-word is not supported by Eon.
3.2 Manufacturer ID
Eon’s device uses an extended manufacurer identification code at address 100h ,
instead of address 000h. Thus, on address 100h, the output is 1Ch ;while on address
000h, the output is 7Fh.
3.3 Autoselect command during erase suspend mode.
The auto-select command sequence allows the host system to access the
manufacturer and device codes, and determine whether or not a sector is protected.
Normally, it is initiated from read mode. For EN29LV640T/B, in erase suspend mode
while an erase operation has been suspended, the system can read data from any
sector not selected for erasure. However, manufacturer and device codes can not be
read out by writing auto-select command sequence during this period. In other words,
Auto-select command is not supported during erase suspend mode in EN29LV640T/B,
however S29GL064A supports it.
3.4
Page Read & Write buffer
S29064A has 4-word/8-byte page read buffer and 16-word/32-byte write buffer in
accordance with the commands, write-to-buffer, program-buffer-to-flash, and
write-to-buffer-abort-reset. These are not available for EN29LV640T/B.
3.5
Continuous Sector Erasure
Sector erase is a six bus cycle operation as defined in the datasheet of EN29LV640T/B.
Once the sector erase operation has begun, only the erase suspend command is valid.
All other commands are ignored. Unlike the devices from other vendors, only a single
sector can be specified for each sector erase command.
Users must issue another sector erase command for the next sector to be erased after
the previous one is completed.
3.6
VID and VHH is 11.5V Max.
VID applied to enable Signature (Auto-select) and sector(group) protection and VHH
applied to Accelerated Program are between 10.5V and 11.5V. The same parameters
for S29064M are 11.5V to 12.5V.
Any voltage level higher than 11.5V would damage the device.
This Application Note may be revised by subsequent
versions or modifications due to changes in technical
specifications.
Rev. A, Issue Date: 2007/ 08/ 06
©2005 Eon Silicon Solution, Inc., www.essi.com.tw
Eon Silicon Solution Inc.
Page4/5
4. Conclusion
EN29LV640T/B are compatible with Spansion S29GL064A on the major features.
Moreover Eon has faster word program time 8μs (Spansion 15us) and lower active
read current 9mA, ( Spansion 18mA ) which is more useful in practice.
Note:
1. Cross reference to other parts of Spansion S29GL064A family
S29GL064AxxxR1 = Uniform sector device, highest address sector protected when WP#/ACC=VIL ;
x8 and x16 capable, 56 pin TSOP, no cross to this part
S29GL064AxxxR2 = Uniform sector device, lowest address sector protected when WP#/ACC=VIL ;
x8 and x16 capable, 56 pin TSOP, no cross to this part
S29GL064AxxxR5 = Uniform sector device, x16 only, FBGA, no cross to this part
S29GL064AxxxR6 = Uniform sector device, highest address sector protected when WP#=VIL
x16 only, 48 pin TSOP, cross to EN29LV641H
S29GL064AxxxR7 = Uniform sector device, lowest address sector protected when WP#=VIL
X16 only, 48 pin TSOP, cross to EN29LV641L
This Application Note may be revised by subsequent
versions or modifications due to changes in technical
specifications.
Rev. A, Issue Date: 2007/ 08/ 06
©2005 Eon Silicon Solution, Inc., www.essi.com.tw
Eon Silicon Solution Inc.
Page5/5
Revisions History
Revision No
Description
Date
A
Initial Release.
2007/08/06
This Application Note may be revised by subsequent
versions or modifications due to changes in technical
specifications.
©2005 Eon Silicon Solution, Inc., www.essi.com.tw
Rev. A, Issue Date: 2007/ 08/ 06