● ● ● ● ● Features LED DRIVER ● ● ● Universal AC Input Constant Current Operation Suitable for High Brightness LED Products Built-In Active PFC Function Overvoltage-, Short Circuit- and Overtemperature Protection Built-In 3 in 1 Dimming IP67 Rated Class 2 Power Unit UL1310 LIGHTLINE AC/DC-Converter with 5 year Warranty Selection Guide Output Voltage (VDC) Rated Power (W) Rated Current (mA) Output Voltage Range (V) Efficiency RACD60-1050A 57 60 105 - 1050 40 - 57 88% RACD60-1200A 48 58 120 - 1200 33 - 48 88% RACD60-1650A 36 60 165 - 1650 24 - 36 87% RACD60-2500A 24 60 250 - 2500 15 - 24 86% RACD60-4200A 12 50 420 - 4200 9 - 12 86% Part Number (typ.) 60 Watt PFC Single Output Specifications (measured at 230VAC and 25°C ambient temperature) Input Voltage Range Input Frequency Range Power Factor (Full Load) L-54 REV: 0/2015 RoHS 2011/65/EU 6/6 E340696 EN 61347-1 Certified EN 61347-2-13 Certified UL8750 Certified RACD60-A Derating-Graph (Ambient Temperature) Load 100% 90% 75% 60% 230VAC only 90-305 VAC 47-63Hz 120VAC >0.98 240VAC >0.94 277VAC >0.92 THD Full Load, 115VAC 12% max. Full Load, 230VAC 18% max. DC Dimming DC 1-10V PWM Dimming Puls: Hi=10V Low=0V, Duty: 10% - 100%, Fsw 0.5 - 3KHz Resistance Dimming 10K - 100K Ω Current Accuracy ±5% AC Input Current 100-240VAC 0.8A 277VAC 0.4A Inrush Current (Cold Start) 240VAC 70A Leakage Current <0.5mA / 240VAC Start-up Time (at Full Load) <2sec Isolation Voltage 3.75kVAC / 1 minute Short Circuit Protection Hiccup Over Voltage Protection 12V 13.2 - 15.6V 24V 26.4 - 31.2V 36V 39.6 - 46.8V 48V 52.8 - 62.4V 57V 62.7 - 70V Over Temperature Protection 105 ± 10°C, Latch Mode Vibration 10-500Hz, 2G, 60 Min. along X, Y and Z Storage Humidity 10% - 90% RH Operating Humidity 20% - 90% RH Non-Condensing Weight 420g Operating Temperature -30°C to +50°C Storage Temperature -40°C to +60°C Ripple & Noise 12V, 24V 200mV (at 20MHz bandwidth using 0.1uF & 47uF capacitor) 36V, 48V, 57V 250mV IP Rating IP67 Isolation Resistance 100MΩ / 500VDC at 25°C Dimension (L*W*H) 179*45.1*32.5mm Design Lifetime 70 x 10³ hours max. MTBF (+25°C) using MIL-HDBK 217F 200 x 10³ hours min. continued on next page 40% 20% -30 0 20 50 65 Ambient Temperature (°C) Note: All LED Drivers may not be used without a load. They must be switched on the primary side only. Noncompliance may damage the LED or reduce its lifetime. Refer to Application Notes www.recom-power.com RACD60-A Series LIGHTLINE AC/DC-Converter Specifications (measured at 230VAC and 25°C ambient temperature) Safety Standards LED Lighting Safety LED Lighting Safety (Canada) Class 2 Power Supply Safety Extra Low-Voltage Class 2 Output LED equipment for lighting application Report: E340696 Report: E340696 Report: E340696 Report: E340696 Report: E340696 UL8750 cUL8750 UL1310 CSA C22.2 No. 223-M91 CSA C22.2 No. 250.13-12 EN61347-1 EN61347-2-13 EN61000-3-2 Class C EN61000-3-3 EN61000-4-2,3,4,5,6,8,11 EN61547 EN55015 FCC15 3 in 1 Dimming Control (DC / PWM / Resistance) 10K-100K Resistor Dimmable (Typical): Resistor Single-Driver 10K 20K 30K 40K 50K 60K 70K 80K 90K 100K Multi-Driver 10K/N 20K/N 30K/N 40K/N 50K/N 60K/N 70K/N 80K/N 90K/N 100K/N 60% 70% 80% 90% 100% DC: 10V / PWM Dimmable (Typical) 100 100 80 80 Output Current (%) Output Current (%) Iout (%) 10% 20% 30% 40% 50% The length of extended wire for DIM+/- shall not exeed 20 meters. (wire ≤ 20m) N = The number of dimmer drivers should not exceed 15. (N ≤ 15mS) DC: 1-10V Dimmable (Typical) 60 40 20 0 0 2 4 6 8 60 40 20 0 10 0 20 40 Efficiency (%) 80 100 Duty Cycle (%) Typical Characteristics Efficiency vs Load over Vin RACD60-2500A Maximum Number of LED drivers per circuit breakers Condition 90 89 88 277 VAC 87 86 85 84 83 82 81 80 14 16 60 RACD60-A Control Voltage (V) Circuit Breaker Circuit Breaker Current Typ 10A 16A 20A 25A 115VAC, 1Ohm 90° phase angle C 12 20 24 31 230VAC, 1Ohm 90° phase angle B C 13 21 21 35 25 41 32 51 277VAC, 1Ohm 90° phase angle B C 15 24 24 40 29 47 37 58 230 VAC 110 VAC 18 20 22 24 Output Voltage (V) Package Style & Pinning AC IN AC N (Blue) AC L (Brown) 170±15 Tc 35.7 DC OUT +DIM 164 fixing center 8 6 AC Side V+ (Red) V- (Black) fixing Dim+ (Blue) center Dim- (White) 38 13 32.5 8 160±15 6 3.5 Note: Dim- and V- are internally connected TOP 14 10 6 13 10 BOTTOM 0.8 DC Side 8 170±15 45.1 0.8 8 160±15 0.8 23 The product information and specifications are subject to change without prior notice. RECOM products are not authorized for use in safety-critical applications (such as life support) without RECOM’s explicit written consent. A safety-critical application is defined as an application where a failure of a RECOM product may reasonably be expected to endanger or cause loss of life, inflict bodily harm or damage property. The buyer shall indemnify and hold harmless RECOM, its affiliated companies and its representatives against any damage claims in connection with the unauthorized use of RECOM products in such safety-critical applications. www.recom-power.com REV: 0/2015 L-55