7320 - Crane Aerospace & Electronics

Crane Aerospace & Electronics Microwave Solutions
VOLTAGE CONTROLLED OSCILLATOR 7320 SERIES
TECHNICAL FEATURE
FEATURES

Broadband, voltage tuning

Low post-tuning drift (PTD)

Low FM noise

Wideband FM Modulation

Output buffer amplifier and filter

Internal voltage regulation

Hermetically sealed
Frequency Range (Note 1)
Tuning Bandwidth
Power Output
Post Tuning Drift
(1 µS to 10 S)
Harmonics
Phase Noise (SSB)
@ 100 kHz offset
Bias Pushing
Load Pulling
(2.0:1 VSWR)
0.8 to 3.0
52
2 to 5
51
±1
4 to 8
48
6 to 11
35
+13
±2
10 to 15
29
±3
-30
-95
-90
±4
-25
-85
-80
-80
-75
200
±2.5
±10
±15
100
50
±10
dBc, max.
dBc/Hz, typ.
V min.
V max.
125
50
DC to 20
-54 to +85
SMA Female
Solder Pin
1.00 x 2.05 x 0.43
GHz
%, max.
dBm, nom.
MHz, max.
kHz/V, max.
MHz max.
-10
+10
Tuning Voltage Range (Note 2)
DC Power
+15V
-15V
Modulation Bandwidth
Temperature Range
RF Connectors
DC and Tuning
Dimensions
13 to 20
26
1.00 x 1.90 x 0.43
175
100
mA typ.
mA typ.
MHz
°C
Inches
Note1; The bandwidth of a VCO within a given Frequency Range is limited to the maximum percentage Tuning Bandwidthe indicated
for each Frequency Range.
Note 2: Most VCOs will tune the required Frequency Range between -6 V and +8 V. Applying a Tuning Voltage 1 V mor negative than
the most negative vule idnetified with the delivery of each VCO may cuase permanent damge to the VCO. Appling a Tuning Voltage
more negative than -1 prior to the application of the negative supply voltage may cause permanent damage to the VCO.
Crane Aerospace & Electronics
Microwave Solutions – Signal Technology
340 North Roosevelt Avenue, Chandler, AZ 85226
+1.480.961.6293  [email protected]
www.craneae.com/mw
The information in this document is a derivative of a document cleared by the Department of Defense (DoD) Office of Security Review (OSR) for public release.
OSR case number 10-S-0983 dated March 11, 2010. DS_7320_ Voltage Controlled Oscillator_MW_2010.doc. This revision supersedes all previous releases.
All technical information is believed to be accurate, but no responsibility is assumed for errors. We reserve the right to make changes in products or
specifications without notice. Copyright © 2010 Crane Electronics, Inc. All rights reserved.