HS201DR Series • 35 & 38 amp AC output @ 40°C • Dual Channel output • 4 to 32 VDC input control voltage • DIN Rail mounted • UL, cUL, CE approved SSRs PRODUCT SELECTION Description 4-32 VDC Control 35 A 38 A HS201DR-CC2425W3U HS201DR-CD4850W4U HS201DR-CC2425W3U HS201DR-CD4850W4U 24-280 600 0.1 500 35 0.15 275/300 1.3 380/370 0.5 48-660 1200 0.25 500 38 0.15 710/750 1.7 2520/2320 0.5 OUTPUT SPECIFICATIONS (1) Description Operating Voltage (47-63Hz) [Vrms] Transient Overvoltage [Vpk] Maximum Off-State Leakage Current @ Rated Voltage [mArms] Minimum Off-State dv/dt @ Maximum Rated Voltage [V/µsec] (2) Maximum Load Current [Arms] Minimum Load Current [Arms] Maximum 1 Cycle Surge Current (50/60 Hz) [Apk] Maximum On-State Voltage Drop @ Rated Current [Vpk] Maximum I²t for fusing (50/60 Hz, 1/2 cycle) [A² sec] Minimum Power Factor (with Maximum Load) INPUT SPECIFICATIONS (1) Description Control Voltage Range Minimum Turn-On Voltage Minimum Turn-Off Voltage Maximum Reverse Voltage Typical Input Current Nominal Input Impeadance Maximum Turn-On Time [msec] Maximum Turn-Off Time [msec] Parameters 4-32 VDC 4.0 VDC 1.0 VDC 32 VDC 10 mA @ 12 VDC (3) 1/2 Cycle 1/2 Cycle GENERAL SPECIFICATIONS Description Dielectric Strength, Input/Output/Base (50/60Hz) Minimum Insulation Resistance (@ 500 V DC) Maximum Capacitance, Input/Output Ambient Operating Temperature Range Ambient Storage Temperature Range Status Indicator Display Weight (typical) Encapsulation Load Terminals Screw Torque Range Thermal pad installed GENERAL NOTES 1) All parameters at 25°C unless otherwise specified. 2) Off-State dv/dt test method per EIA/NARM standard RS-443, paragraph 13.11.1 3) Input circuitry for DC control version incorporates active current limiter. NOTE: For more information see Evolution Dual spec sheet. Parameters 4000 Vrms 109 Ohms 10 pF -40 to 80˚C -40 to 125˚C Yes 1.03 lb (453g) Themally Conductive Epoxy 18-20 in/lbs (2.0-2.26 Nm) Yes MECHANICAL SPECIFICATIONS THERMAL DERATE INFORMATION AGENCY APPROVALS Designed in accordance with the requirements of IEC 62314 Agency approvals are for relay only. E116950 Rev. 110911 ANNEX - ENVIROMENTAL INFORMATION