Technical Data Metal Switches

Technical Data
Metal Switches
Series GC
Description
GC-U1Z VT 90GR
Article number
6121100555
Operating symbol
Operating diagram
Actuator
withdraw
Blind hole for fitting pin
Ø4; 5.5 deep
Actuator
inserted
ON
OFF
Built in dimension
Tolerances
Operating point: ± 0,3mm;
Operating torque: ± 10%
Electrical data
Rated insulation voltage
Conv. thermal current
Utilization category
Positive opening NC contact
Short-circuit protective device
Protection class
Ui
Ithe
400 VAC
10A
AC-15, Ue /Ie 240V/3A
acc. to IEC/EN 60947-5-1, Annex K
Fuse 10A gL/gG
I
This document will not become the contractual basis; the details included herein do not constitute any descriptions of expected conditions, so that warranties/claims for
defects on account of possible variations of the actual qualities from the qualities described herein are explicitly excluded. All rights reserved. Specifications subject to
change without notice!
Date of issue: 07.03.2006 / Page 1 of 2
Document: 6121100555_en / Last update: 1 / 2217-06
Bernstein AG, Tieloser Weg 6, D-32457 Porta Westfalica, Germany / www.bernstein-ag.de
Vorlage : 0850174282 Orig. 1
Technical Data
Metal Switches
Mechanical data
Enclosure
Cover
Actuator
Ambient air temperature
Contact type
Mechanical life
Switching frequency
Assembly
Connection
Conductor cross-sections
Cable entrance
Weight
Installation position
Protection type
Standards
Die-cast aluminium
Sheet aluminium
Separate actuator
-30°C ... +80°C
1 NC, 1 NO (Zb)
6
1 x 10 operating cycles
≤ 10 / min.
2 x M4
4 screw terminals (M3,5)
Solid: 0.5 ... 1.5mm²
Litz wire with ferrules: 0.5 ... 1.5mm²
1 x cable gland
(M20x1,5; clamp-range 6 – 12mm),
≈ 0,32 kg
Operator definable
IP65 acc. to IEC/EN 60529
VDE 0660 T100, DIN EN 60947-1, IEC 60947-1
VDE 0660 T200, DIN EN 60947-5-1, IEC 60947-5-1
EU Conformity
Approvals
BG
UL A300 (same polarity)
Notes
The specified protection classification (IP code) applies only when the cover is closed and the appropriate cable is
used, in accordance with the clamping range of the above mentioned cable gland.
Mounting:
When used as safety switch pay attention to EN 60204 (use NC-contacts).
Also secure by a set pin (hole within the bottom of the case).
Actuator to be fixed with 4 screws M4 at the movable guard.
Please pay attention to the specified maximum of misalignment of the actuator.
Position of the actuator head determined at works, must not be modified.
Screws obviously secured.
This document will not become the contractual basis; the details included herein do not constitute any descriptions of expected conditions, so that warranties/claims for
defects on account of possible variations of the actual qualities from the qualities described herein are explicitly excluded. All rights reserved. Specifications subject to
change without notice!
Date of issue: 07.03.2006 / Page 2 of 2
Document: 6121100555_en / Last update: 1 / 2217-06
Bernstein AG, Tieloser Weg 6, D-32457 Porta Westfalica, Germany / www.bernstein-ag.de
Vorlage : 0850174282 Orig. 1