Model C100N50Z4 Surface Mount Termination 100 Watts, 50Ω Description The C100N50Z4 is high performance Aluminum Nitride (AlN) surface mount termination intended as a cost competitive alternative to Beryllium Oxide (BeO). The termination is well suited to all cellular frequency bands such as; AMPS, GSM, DCS, PCS, PHS and UMTS. The high power handling makes the part ideal for terminating high power 90 degree couplers, and for use in microstrip circuits. The termination is also RoHS compliant! General Specifications Features: • RoHS Compliant • 100 Watts • DC – 4.0 GHz • AlN Ceramic • Non-Nichrome Resistive Element Resistive Element Substrate Terminal Finish Operating Temperature Tolerance is ±0.010”, unless otherwise specified. Designed to meet or exceed applicable portions of MIL-E-5400. All dimensions in inches. Electrical Specifications • Low VSWR Resistance Value: Power: Frequency Range: • 100% Tested Return Loss • Small Size Thick film AlN Ceramic Matte Tin over Nickel Barrier -55 to +125°C (see de rating chart) 50 Ohms, ± 2% 100 Watts DC – 4.0 GHz >24 dB DC - 2.7 GHz >20 dB DC - 4.0 GHz Specification based on unit properly installed using suggested mounting instructions and a 50 ohm nominal impedance. Specifications subject to change. Outline Drawing pg. 1 of 2 Available on Tape and Reel For Pick and Place Manufacturing. USA/Canada: Toll Free: Europe: (315) 432-8909 (800) 544-2414 +44 2392-232392 Model C100N50Z4 Typical Performance: Power De-rating: Tape & Reel: *Actual performance could be limited by the solder properties of the application Mounting Footprint and Procedure: pg. 2 of 2 USA/Canada: Toll Free: Europe: (315) 432-8909 (800) 544-2414 +44 2392-232392 Available on Tape and Reel For Pick and Place Manufacturing.