ROHS Compliant Model C50A50Z4 Surface Mount Termination 50 Watts, 50Ω Description The C50A50Z4 is high performance Alumina (Al203) surface mount termination intended as a low cost alternative to Aluminum Oxide (AlN). The termination is well suited to all cellular frequency bands such as; AMPS, GSM, DCS, PCS, PHS and UMTS. The high power handling makes the part ideal for terminating high power 90 degree couplers, and for use in microstrip circuits. The termination is also RoHS compliant! General Specifications Features: • RoHS Compliant • 50 Watts • DC - 2.7 GHz • Al2O3 Ceramic • Non-Nichrome Resistive Element • Low VSWR • 100% Tested • Small Size Resistive Element Substrate Terminal Finish Operating Temperature Thick film Al2O3 Ceramic Matte Tin over Nickel Barrier -55 to +125°C (see de rating chart) Tolerance is ±0.010”, unless otherwise specified. Designed to meet of exceed applicable portions of MIL-E-5400. All dimensions in inches. Electrical Specifications Resistance Value: Power: Frequency Range: Return Loss 50 Ohms, ± 2% 50 Watts DC – 2.7 GHz >26 dB to 2.2 GHz >24 dB to 2.7 GHz Specification based on unit properly installed using suggested mounting instructions and a 50 ohm nominal impedance. Specifications subject to change. Outline Drawing C50A50Z4 (097) rev.C pg. 1 of 2 Available on Tape and Reel For Pick and Place Manufacturing. USA/Canada: Toll Free: Europe: (315) 432-8909 (800) 544-2414 +44 2392-232392 Model C50A50Z4 Typical Performance: Power De-rating: Tape & Reel: Mounting Footprint and Procedure: C50A50Z4 (097) rev.C pg. 2 of 2 USA/Canada: Toll Free: Europe: (315) 432-8909 (800) 544-2414 +44 2392-232392 Available on Tape and Reel For Pick and Place Manufacturing.