Model C10A50Z4 Surface Mount Termination 10 Watts, 50Ω Description The C10A50Z4 is high performance RoHS compliant Alumina (Al2O3) surface mount termination intended as a lower cost alternative to Aluminum Nitride (AlN) and Beryllium Oxide (BeO). The termination is well suited to all cellular frequency bands such as; AMPS, GSM, DCS, PCS, PHS and UMTS. The high power handling makes the part ideal for terminating 90 degree hybrid directional couplers, and for use in isolators. General Specifications Resistive Element Substrate Terminal Finish Operating Temperature Features: • RoHS Compliant Thick film Al2O3 Ceramic Matte Tin over Nickel Barrier -55 to +125°C (see de-rating chart) Tolerance is ±0.010”, unless otherwise specified. Designed to meet of exceed applicable portions of MIL-E-5400. All dimensions in inches. • 10 Watts • DC – 3.0 GHz Electrical Specifications • Al2O3 Ceramic Resistance Value: Power: Frequency Range: V.S.W.R.: • Non-Nichrome Resistive Element • Low VSWR 50 Ohms, ± 2% 10 Watts DC – 3.0 GHz < 1.25:1 Specification based on unit properly installed using suggested mounting instructions and a 50 ohm nominal impedance. Specifications subject to change without notice. • 100% Tested Outline Drawing Note: All dimensions in inches – 1inch = 2.54cm. C10A50Z4 pg. 1 of 2 Available on Tape and Reel For Pick and Place Manufacturing. USA/Canada: Toll Free: Europe: (315) 432-8909 (800) 544-2414 +44 2392-232392 Model C10A50Z4 Typical Performance: C10A50Z4 C10A50Z4 Power De-rating: Mounting Footprint and Procedure: *Actual performance could be limited by the solder properties of the application Tape & Reel Available: C10A50Z4 pg. 2 of 2 USA/Canada: Toll Free: Europe: (315) 432-8909 (800) 544-2414 +44 2392-232392 Available on Tape and Reel For Pick and Place Manufacturing.