Model G200N50W4 Flange Mount Termination 200 Watts, 50Ω Description The G200N50W4 is high performance Aluminum Nitride (AlN) flange mount termination intended as a cost competitive alternative to Beryllium Oxide (BeO). The termination is well suited to all cellular frequency bands such as; AMPS, GSM, DCS, PCS, PHS and UMTS. The high power handling makes the part ideal for terminating circulators and for use in power combiners. The termination is also RoHS compliant! General Specifications Thick Film AlN Ceramic Nickel Plated Copper -50 to +150°C (see de rating chart) • 200 Watts Resistive Element Substrate Mounting Flange Operating Temperature • DC - 2.2 GHz Tolerance is ±0.010”, unless otherwise specified. Designed to meet of exceed applicable portions of MIL-E-5400. All dimensions in inches. Features: • RoHS Compliant • AlN Ceramic • Non-Nichrome Resistive Element • Low VSWR • 100% Tested Electrical Specifications Resistance Value: Power: Frequency Range: Return Loss 50 Ohms, ± 2% 200 Watts DC – 2.2 GHz > 20 dB from DC to 2.2 GHz Specification based on unit properly installed using suggested mounting instructions and a 50 ohm nominal impedance. Specifications subject to change. Outline Drawing UNLESS OTHERWISE SPECIFIED DIMENSIONS ARE IN INCHES 1 of 2 USA/Canada: Toll Free: Europe: (315) 432-8909 (800) 544-2414 +44 2392-232392 Model G200N50W4 Typical Performance: G200N50W4 G200N50W4 Power De-rating: Mounting Footprint and Procedure: *Actual performance could be limited by the solder properties of the application 2 of 2 USA/Canada: Toll Free: Europe: (315) 432-8909 (800) 544-2414 +44 2392-232392