ROHS Compliant Model H100NA30X4 Flange Attenuator 100 Watts, 30 dB Description The H100NA30X4 is high performance Aluminum Nitride (AlN) high power flange mount attenuator intended as a cost competitive alternative to Beryllium Oxide (BeO). The termination is well suited to all cellular frequency bands such as; AMPS, GSM, DCS, PCS, PHS and UMTS. The high power handling makes the part ideal for terminating circulators, and for use in power monitoring. The termination is also RoHS compliant! General Specifications Features: • RoHS Compliant • 100 Watts • DC – 4.0 GHz • AlN Ceramic • Non-Nichrome Resistive Element • Low VSWR • 100% Tested • Small Size Resistive Element Substrate Cover Mounting Flange Operating Temperature Thick film AlN Ceramic Alumina Ceramic Nickel Plated Copper -55 to +150°C (see de rating chart) Tolerance is ±0.010”, unless otherwise specified. Designed to meet of exceed applicable portions of MIL-E-5400. All dimensions in inches. Electrical Specifications Attenuation Value: Power: Frequency Range: Return Loss 30 dB, +5/-2 dB, DC - 2.2 GHz 30 dB, +7/-2 dB, 2.2 GHz – 2.7 GHz 100 Watts DC – 2.7 GHz >24 dB to 2.2 GHz >20 dB to 4.0 GHz Specification based on unit properly installed using suggested mounting instructions and a 50 ohm nominal impedance. Specifications subject to change. Outline Drawing H100NA30X4 (097) rev.B pg. 1 of 2 USA/Canada: Toll Free: Europe: (315) 432-8909 (800) 544-2414 +44 2392-232392 Model H100NA30X4 Typical Performance: Power De-rating: Mounting Footprint and Procedure: H100NA30X4 (097) rev.B pg. 2 of 2 USA/Canada: Toll Free: Europe: (315) 432-8909 (800) 544-2414 +44 2392-232392