Model A15N50X4 Chip Termination 15 Watts, 50Ω Description The A15N50X4 is high performance Aluminum Nitride Chip termination intended as a low cost alternative to BeO. The termination is well suited to all cellular frequency bands such as; AMPS, GSM, DCS, PCS, PHS and UMTS. The termination is also RoHS compliant! General Specifications Thick film AlN Ceramic Matte Tin over Nickel Barrier -55 to +200°C (see de rating chart) • 15 Watts Resistive Element Substrate Terminal Finish Operating Temperature • DC – 4.5 GHz Tolerance is ±0.010”, unless otherwise specified. Designed to meet or exceed applicable portions of MIL-E-5400. All dimensions in inches. Features: • RoHS Compliant • AlN Ceramic • Non-Nichrome Resistive Element • Low VSWR • 100% Tested • Small Size Electrical Specifications Resistance Value: Power: Frequency Range: Return Loss 50 Ohms, ± 2% 15 Watts DC – 4.5 GHz >20 dB Specification based on unit properly installed using suggested mounting instructions and a 50 ohm nominal impedance. Specifications subject to change. Outline Drawing UNLESS OTHERWISE SPECIFIED DIMENSIONS ARE IN INCHES USA/Canada: Toll Free: Europe: (315) 432-8909 (800) 544-2414 +44 2392-232392 Model A15N50X4 2 of 2 Typical Performance: A15N50X4 A15N50X4 0.00 110 100 90 70 60 0.50 130 -10.00 80 1.00 120 -5.00 50 140 40 150 Return Loss (dB) -15.00 160 30 0.20 20 -20.00 170 10 -25.00 180 0.50 1.00 2.00 -0.20 -0.50 0.00 -30.00 -170 -10 -1.00 -35.00 -160 -40.00 -20 -150 -45.00 -30 -140 -40 -130 -50.00 0.00 0 1.00 2.00 F [GHz] 3.00 4.00 4.50 Power De-rating: *Actual performance could be limited by the solder properties of the application USA/Canada: Toll Free: Europe: (315) 432-8909 (800) 544-2414 +44 2392-232392 -50 -120 -60 -110 -100 -90 -80 -70 Mounting Footprint and Procedure: