Model 1615-30 Chip Attenuator 100 Watts, 30 dB Description The 1615-30 is high performance Aluminum Nitride (AlN) chip attenuator intended as a cost competitive alternative to Beryllium Oxide (BeO). The attenuator is well suited to all cellular frequency bands such as; AMPS, GSM, DCS, PCS, PHS and UMTS. The Attenuator is also RoHS compliant! General Specifications Features: • RoHS Compliant • 100 Watts • DC – 2.3 GHz Thick film AlN Ceramic Matte Tin over Nickel Barrier -55 to +200°C (see de rating chart) Resistive Element Substrate Terminal Finish Operating Temperature Tolerance is ±0.010”, unless otherwise specified. Designed to meet of exceed applicable portions of MIL-E-5400. All dimensions in inches. Electrical Specifications ±0.5 dB, DC - 960 MHz +0.5, -1 dB, 960 MHz - 2.3 GHz • AlN Ceramic Attenuation Value: 30 dB • Non-Nichrome Resistive Element Power: Frequency Range: Input Return Loss 100 Watts DC – 2.3 GHz 19dB • Low VSWR • 100% Tested Specification based on unit properly installed using suggested mounting instructions and a 50 ohm nominal impedance. Specifications subject to change. Outline Drawing UNLESS OTHERWISE SPECIFIED DIMENSIONS ARE IN INCHES. TOLERANCES ON DECIMALS .XXX ± .010 1615-30 pg.1 of 2 USA/Canada: Toll Free: Europe: (315) 432-8909 (800) 544-2414 +44 2392-232392 Model 1615-30 Typical Performance: Return Loss Attenuation Power De-rating: *Actual performance could be limited by the solder properties of the application Mounting Procedure: 1615-30 pg.2 of 2 USA/Canada: Toll Free: Europe: (315) 432-8909 (800) 544-2414 +44 2392-232392