DATASHEET Rev. A DTM24 SERIES 90 ~ 264VAC Input Voltage Range Single Outputs, Up to 24 Watts Class II, IEC-320-C8 AC Inlet Medical AC/DC Desktop Power Supplies IEC-320-C8 AC Inlet FEATURES Up to 24 Watts Over Voltage, Over Load, and Short Circuit Protection Single Outputs EMC Compliance RoHS Compliant UL60601-1, EN60601-1, IEC 60601-1 Safety Approvals Output Voltages Available from 5VDC to 48VDC Meets CEC, ERP, EISA, and Energy Star Level V 100% Burn-In and Hi-Pot Tested Requirements Wide Input Voltage Range: 90~264VAC, 47~63Hz Meets UL 1310 NEC Class 2 Requirement High Reliability IEC-320-C8 AC Inlet DESCRIPTION The DTM24 series offers up to 24 watts of output power in a single output desktop power supply. This series has UL606011, EN60601-1, and IEC 60601-1 medical safety approvals. All units are short circuit, over voltage, and over load protected. All models have an IEC-320-C8 AC inlet and output voltages range from 5 to 48VDC. All units meet CEC, ERP, EISA, and Energy Star Level V requirements as well as UL 1310 NEC Class 2 requirements. These supplies are RoHS compliant and have been 100% burn-in and Hi-pot tested. 01/17/2012 Wall Industries, Inc. 5 Watson Brook Road Exeter, NH 03833 603-778-2300 www.wallindustries.com Fax 603-778-9797 Page 1 of 4 Rev. A DTM24 Series Class II, IEC-320-C8 AC Inlet Single Outputs, Up to 24 Watts Medical AC/DC Desktop Power Supplies SPECIFICATIONS: DTM24 Series All specifications are based on 25°C, Nominal Input Voltage, and Maximum Output Current unless otherwise noted. We reserve the right to change specifications based on technological advances. INPUT SPECIFICATIONS Input Voltage Range 90 ~ 264VAC (Full Range) Input Frequency 47 ~ 63Hz 0.7A at 90VAC max. 0.35A at 264VAC max. < 300mW Input Current (rms) No Load Power Consumption OUTPUT SPECIFICATIONS Output Current See Table Output Voltage See Table Voltage Regulation +5% / -3% Output Power See Table Ripple & Noise (See Note 2) ±1% Hold Up Time > 10ms typical at full load and 115VAC PROTECTION Short Circuit Protection Auto-recovery Over Voltage Protection Latch, AC recycle Over Load Protection Auto-recovery ENVIRONMENTAL SPECIFICATIONS Operating Temperature -20°C to +40°C Storage Temperature -20°C to +85°C Humidity 20% to 90% MTBF > 150,000 hours at full load and 25°C ambient temperature PHYSICAL SPECIFICATIONS Dimensions (L x W x H) 3.07 x 1.97 x 1.38 inches (78.0 x 50.0 x 35.0 mm) Net Weight 4.62oz (131g) AC Input (See Note 1) IEC-320-C8 SAFETY & EMI Safety Standards UL 60601-1, CSA-C22.2 NO.601.1-M90, NEMKO EN60601-1, CB IEC60601-1 EMI Standards EN60601-1-2, FCC Part 18 Class B, EN55011 Class B, CE All models meet CEC, ERP, EISA, and Energy Star Level V requirements All models meet UL 1310 NEC Class 2 requirements 01/17/2012 Wall Industries, Inc. 5 Watson Brook Road Exeter, NH 03833 603-778-2300 www.wallindustries.com Fax 603-778-9797 Page 2 of 4 DTM24 Series Class II, IEC-320-C8 AC Inlet Single Outputs, Up to 24 Watts Medical AC/DC Desktop Power Supplies Rev. A MODEL SELECTION TABLE Model Number Input Voltage Range Ripple & Noise (2) Output Regulation Output Voltage Output Current DTM15A1Y05K0 5 VDC 3A 50mVp-p +5% / -3% 15W DTM24A1Y09K0 9 VDC 2.67A 90mVp-p +5% / -3% 24W DTM24A1Y12K0 12 VDC 2A 120mVp-p +5% / -3% 24W 16 VDC 1.5A 160mVp-p +5% / -3% 24W DTM24A1Y18K0 18 VDC 1.34A 180mVp-p +5% / -3% 24W DTM24A1Y24K0 24 VDC 1A 240mVp-p +5% / -3% 24W DTM24A1Y36K0 36 VDC 0.67A 360mVp-p +5% / -3% 24W DTM24A1Y48K0 48 VDC 0.5A 480mVp-p +5% / -3% 24W DTM24A1Y16K0 Output Power 90 ~ 264 VAC NOTES 1. All models have an IEC-320-C8 AC inlet. 2. Ripple and Noise is measured at 20MHz bandwidth with a tantalum 10µF in parallel with a 0.1µF ceramic capacitor. MECHANICAL DRAWINGS Unit: inches (mm) 3.07 (78.0±0.5) PUSH 1.97 (50.0±0.25) DESKTOP (C8) TOP 1.38 (35.00±0.25) LABEL 01/17/2012 POWER LED SIDE Standard Output Cable 1. AWM 1185 # 18 AWG / 1C + SHIELDING, UL 80°C 300V VW-1, 1550 mm 2. Depends on customer’s requirements. Wall Industries, Inc. 5 Watson Brook Road Exeter, NH 03833 603-778-2300 www.wallindustries.com Fax 603-778-9797 Page 3 of 4 Rev. A DTM24 Series Class II, IEC-320-C8 AC Inlet Single Outputs, Up to 24 Watts Medical AC/DC Desktop Power Supplies COMPANY INFORMATION Wall Industries, Inc. has created custom and modified units for over 50 years. Our in-house research and development engineers will provide a solution that exceeds your performance requirements on-time and on budget. Our ISO9001-2008 certification is just one example of our commitment to producing a high quality, welldocumented product for our customers. Our past projects demonstrate our commitment to you, our customer. Wall Industries, Inc. has a reputation for working closely with its customers to ensure each solution meets or exceeds form, fit and function requirements. We will continue to provide ongoing support for your project above and beyond the design and production phases. Give us a call today to discuss your future projects. Contact Wall Industries for further information: Phone: Toll Free: Fax: E-mail: Web: Address: 01/17/2012 (603)778-2300 (888)587-9255 (603)778-9797 [email protected] www.wallindustries.com 5 Watson Brook Rd. Exeter, NH 03833 Wall Industries, Inc. 5 Watson Brook Road Exeter, NH 03833 603-778-2300 www.wallindustries.com Fax 603-778-9797 Page 4 of 4