Rev. D PSM200 Series Single Output 200 Watt, U-Chassis AC/DC Medical Power Supply FEATURES ● Active PFC ● Single Output ● High Reliability ● RoHS Compliant ● Medical Approved ● 100% Hi-pot Tested ● 100% Burn-in Tested ● 90~264VAC Input Range ● Safety Approvals, EMC Compliance ● Short Circuit, Over Load, and Over Voltage Protected DESCRIPTION The PSM200 series of AC/DC medical power supplies provides 200 Watts of continuous output power in a U-chassis design. All models have a single output, 90~264VAC full range input, and active PFC. These supplies are designed to comply with UL60601-1, TUV EN60601-1, and CB IEC60601-1 requirements. All models are protected against short circuit, over load, and over voltage conditions. This series is 100% hi-pot and burn-in tested. SPECIFICATIONS: PSM200 Series All specifications are based on 25°C, Nominal Input Voltage, and Maximum Output Current unless otherwise noted. We reserve the right to change specifications based on technological advances. INPUT SPECIFICATIONS Input Voltage Range Input Frequency Input Current (rms) Leakage Current OUTPUT SPECIFICATIONS Output Current Output Voltage Voltage Regulation Output Power Ripple & Noise (20MHz BW) (See Note 1) Hold Up Time PROTECTION Short Circuit Protection Over Voltage Protection Over Load Protection GENERAL SPECIFICATIONS Efficiency No Load Power Consumption Power Factor ENVIRONMENTAL SPECIFICATIONS Operating Temperature Storage Temperature Humidity MTBF PHYSICAL SPECIFICATIONS Dimensions (L x W x H) Weight SAFETY & EMI Safety Standards EMC Standards 08/01/2011 90 ~ 264VAC (Full Range) 47 ~ 63Hz 3A at 90VAC max. 1.5A at 264VAC max. < 300µA at 264VAC See Table See Table ±5% 200W max. See Table > 16ms typical at 115VAC and full load Auto recover Latch, AC recycle Auto recover > 87% at 115VAC and full load < 500mW > 0.9 at 115VAC/230VAC and full load 0°C ~ +40°C convection cooling -10°C to +85°C 20% ~ 90% >140,000 hours at full load and 25°C ambient temperature 6.94 x 3.74 x 1.97 inches 176 x 95 x 50 mm 1.3 lbs (580g) UL/c-UL UL60601-1, CSA C22.2-No. 60601-1, TUV EN60601-1, CB IEC60601-1 EN60601-1-2, FCC Part 18 Class B, EN55011 Class B, CE Wall Industries, Inc. 5 Watson Brook Road Exeter, NH 03833 603-778-2300 www.wallindustries.com Fax 603-778-9797 Page 1 of 3 PSM200 Series Single Output 200 Watt, U-Chassis AC/DC Medical Power Supply Rev. D MODEL SELECTION GUIDE Model Input Voltage Output Voltage Output Current Ripple & Noise Output Power PSM200A3-1Y12 90 ~ 264 VAC 12 VDC 16.66A 240mVp-p 200W PSM200A3-1Y16 90 ~ 264 VAC 16 VDC 12.50A 300mVp-p 200W PSM200A3-1Y19 90 ~ 264 VAC 19 VDC 10.53A 300mVp-p 200W PSM200A3-1Y20 90 ~ 264 VAC 20 VDC 10A 300mVp-p 200W PSM200A3-1Y24 90 ~ 264 VAC 24 VDC 8.33A 300mVp-p 200W PSM200A3-1Y36 90 ~ 264 VAC 36 VDC 5.555A 300mVp-p 200W PSM200A3-1Y48 90 ~ 264 VAC 48 VDC 4.166A 300mVp-p 200W NOTES 1. Ripple & Noise is measured at 20MHz bandwidth with a tantalum 10µF in parallel with a 0.1µF ceramic capacitor. DERATING CURVE 120 100 50°C forced air cooling 12CFM Load (%) 80 60 40 20 0 0 10 20 30 40 50 60 70 80 90 Ambient Temperature (°C) 08/01/2011 Wall Industries, Inc. 5 Watson Brook Road Exeter, NH 03833 603-778-2300 www.wallindustries.com Fax 603-778-9797 Page 2 of 3 PSM200 Series Single Output 200 Watt, U-Chassis AC/DC Medical Power Supply Rev. D MECHANICAL DRAWING Unit: inches (mm) 6.93 (176.0) 0.24 (6.0) 3.74 (95.0) 0.30 (7.5) + N L 0.91 (23.0) 0.79 (20.0) 1.85 (47.0) 0.91 (23.0) 1.97 (50.0) FG 0.79 (20.0) 0.24 (6.0) 0.24 (6.0) 0.30 (7.5) 0.30 (7.5) M3 (MOUNTING HOLES) x 6 0.30 (7.5) 0.30 (7.5) 0.24 (6.0) 0.24 (6.0) 08/01/2011 Wall Industries, Inc. 5 Watson Brook Road Exeter, NH 03833 603-778-2300 www.wallindustries.com Fax 603-778-9797 Page 3 of 3