DTAM200 Series Rev. A Active PFC 200 Watt Single Output AC/DC Medical Desktop Power Supply FEATURES ● High Reliability ● Universal Input ● 100% Hi-Pot Tested ● 100% Burn-In Tested ● IEC-320-C14 AC Inlet ● Safety Approvals, EMC Compliance ● 40 mm Cooling Fan with Fan Speed Control ● Meets CEC and Energy Star Level IV Requirements ● Short Circuit, Over Load, and Over Voltage Protected SPECIFICATIONS: DTAM200 Series All specifications are based on 25°C, Nominal Input Voltage, and Maximum Output Current unless otherwise noted. We reserve the right to change specifications based on technological advances. INPUT SPECIFICATIONS Input Voltage Range Input Frequency Input Current (rms) OUTPUT SPECIFICATIONS Output Current Output Voltage Output Power Voltage Regulation Ripple & Noise (20MHz BW) Hold Up Time PROTECTION Short Circuit Protection Over Voltage Protection Over Load Protection GENERAL SPECIFICATIONS 90 - 264VAC (Full Range) 47 - 63Hz 3A @ 90VAC max; 1.5A @ 264VAC max See Table See Table 200W max. ±5% See Table >16ms typical at full load and 115VAC Auto recover Latch, AC Recycle Auto recover Efficiency Power Factor No Load Power Consumption (green functions) ENVIRONMENTAL SPECIFICATIONS Operating Temperature Storage Temperature Humidity Cooling MTBF PHYSICAL SPECIFICATIONS Dimensions (L x W x H) AC Input SAFETY & EMI Safety Standards EMC Standards > 87% @ full load and 115VAC > 87% @ average load and 115/230VAC for CEC compliant models. > 0.9 @ full load and 115 / 230VAC < 500mW 0°C to +40°C -10°C to +85°C 20% ~ 90% 40 mm cooling fan with fan speed control >80,000 hours at full load and 25°C ambient temperature 7.42 x 4.11x 2.36 inches 188.5 x 104.5 x 60.0 mm IEC 320-C14 Inlet UL60601-1, CSA C 22.2-No. 60601-1, TUV EN60601-1, CB IEC60601-1 EN60601-1-2, FCC Part 18 Class B, EN55011 Class B, CE Wall Industries, Inc. 5 Watson Brook Road Exeter, NH 03833 603-778-2300 www.wallindustries.com Fax 603-778-9797 DTAM200 Series Active PFC 200 Watt Single Output AC/DC Medical Desktop Power Supply Rev. A OUTPUT VOLTAGE / CURRENT RATING CHART Model Output Voltage Output Current Output Power Output Regulation Ripple & Noise CEC (IV) Energy Star DTAM-200A3-1Y12E DTAM-200A3-1Y16E DTAM-200A3-1Y19E DTAM-200A3-1Y20E DTAM-200A3-1Y24E DTAM-200A3-1Y36E DTAM-200A3-1Y48E 12 VDC 16 VDC 19 VDC 20 VDC 24 VDC 36 VDC 48 VDC 16.66 A 12.5 A 10.53 A 10 A 8.33 A 5.555 A 4.166 A 200W 200W 200W 200W 200W 200W 200W ±5% ±5% ±5% ±5% ±5% ±5% ±5% 240mVp-p 300mVp-p 300mVp-p 300mVp-p 300mVp-p 300mVp-p 300mVp-p V V V V V V V V (1.1) V (2.0) V (2.0) V (2.0) V (2.0) V (2.0) V (2.0) NOTES 1. Ripple & Noise is measured at 20MHz bandwidth with a tantalum 10uF in parallel with a 0.1uF ceramic capacitor. MECHANICAL DRAWING Unit: inches [mm] STANDARD OUTPUT CABLE 1. 12VDC: AWM 2464 #16AWG / 6C + SHIELDING, UL 80°C 300V VW-1, 1000mm ±30mm (MIN) 16VDC and up: AWM 2464 #16AWG / 4C + SHIELDING, UL 80°C 300V VW-1, 1800mm ±30mm (MIN) 2. Depends on customer’s requirements. Wall Industries, Inc. 5 Watson Brook Road Exeter, NH 03833 603-778-2300 www.wallindustries.com Fax 603-778-9797