Model MM9xMS-6 Model MM9xMS-15 Triple Balanced Mixer RF 2.0 to 19.0 GHz Ultra-Broadband Electrical Specifications: (1) Specifications Conditions Parameter SSB Conversion loss:(2) (3) Isolation LO to RF: RF (GHz) 3.0-19.0 2.0-19.0 LO to IF: LO (GHz) 3.0-19.0 2.0-19.0 IF (GHz) 2.0-7.0 1.0-9.0 Min 2.0-4.0 4.0-19.0 2.0-4.0 4.0-19.0 18 20 15 19 RF to IF: IF to RF: Input 1-dB Compression Point: 2.0-19.0 2.0-19.0 2.0-19.0 1.0-9.0 Input Third Order Intercept Point: 2.0-19.0 2.0-19.0 1.0-9.0 LO Power: (4) 2.0-19.0 2.0-19.0 1.0-9.0 1.0-9.0 dB dB dB dB Typical 6.5 dB 8.0 dB Max 9.0 dB 11.0 dB 23 dB 31 dB 21 dB 23 dB 27 dB 27 dB +5 dBm +8 dBm +12 dBm +15 dBm +14 dBm +17 dBm +21 dBm +24 dBm +10 dBm +13 dBm +17 dBm +21 dBm MM94 MM96 MM97 MM98 MM94 MM96 MM97 MM98 MM94 MM96 MM97 MM98 Notes: 1. Specifications are guaranteed when tested as a downconverter in a 50 Ohm system at +25˚C with the nominal LO power. Specifications indicated as typical are not guaranteed. 2. Noise figure is typically within ±0.5 dB of conversion loss. 3. Conversion loss typically degrades less than 0.5 dB at +100˚C and improves less than 0.5 dB at -55˚C. 4. Usable LO drives are up to 2 dB below and 3 dB above nominal. Model MM9xMS-6 Model MM9xMS-15 LO Power 4 = +10 dBm 6 = +13 dBm 7 = +17 dBm 8 = +21 dBm Typical Performance at 25˚C MM9xMS-6 Outline: MS3AL MM9xMS-15 Outline: MS3BL NOTES: (UNLESS OTHERWISE SPECIFIED) 1. LO, RF, AND IF TRACES ARE .02 [.05] WIDE PLATED COPPER SUITABLE FOR SOLDER ATTACH. RELIEF ON MOUNTING SURFACE REQUIRED FOR COMPONENT CLEARANCE. All dimensions are in inches and [mm]. Spectrum Microwave · 2144 Franklin Drive N.E. · Palm Bay, FL 32905 · PH (888) 553-7531 · Fax (888) 553-7532 www.SpectrumMicrowave.com Spectrum Microwave · 2707 Black Lake Place · Philadelphia, PA 19154 · PH (215) 464-4000 · Fax (215) 464-4001 REV A 5/7/10