jupiter Ex ia

(13)
SCHEDULE
(14)
to EC-Type Examination Certificate DEKRA 11ATEX0039 X
(15)
Description
Issue No. 1
The Magnetostrictive Level Transmitter Jupiter Model 2..-E…-…..-… is used for level detection.
Using the principle of magnetostriction and the effect of a magnetic field on the magnetostrictive
wire, a fluid level is converted into a 4 - 20 mA current signal with Hart communication or into a
digital fieldbus signal.
The maximum probe length is 9,75 m.
The transmitter enclosure provides a degree of protection IP66 as per EN 60529.
Ambient temperature range -40 °C to +70 °C.
Electrical data
Level Transmitter Jupiter Model 24.-E…-…..-… and Model 26.-E…-…..-… and
Model 27.-E…-…..-…:
Output/supply circuit (terminals + and -):
in type of protection intrinsic safety Ex ia IIC, only for connection to a certified intrinsically safe
circuit, with the following maximum values:
Ui = 28,4 V; Ii = 120 mA; Pi = 0,84 W; Ci = 2,2 nF; Li = 3 µH.
Level Transmitter Jupiter Model 25.-E…-…..-… and Model 28.-E…-…..-…:
Output/supply circuit (terminals + and -):
in type of protection intrinsic safety Ex ia IIC, suitable for connection to a FISCO fieldbus system
in accordance with EN 60079-27, with the following maximum values:
Ui = 17,5 V; Ii = 380 mA; Pi = 5,32 W; Ci = 3 nF; Li = 3 µH.
or
in type of protection intrinsic safety Ex ia IIC, only for connection to a certified intrinsically safe
circuit, with the following maximum values:
Ui = 28,4 V; Ii = 120 mA; Pi = 0,84 W; Ci = 3 nF; Li = 3 µH.
(16)
Test Report
NL/KEM/ExTR08.0014/**.
(17)
Special conditions for safe use
Because the enclosure of the Magnetostrictive Level Transmitter Jupiter Model 2.1-E…-…..-… or
Model 2.2-E…-…..-… is made of aluminium, if it is mounted in an area where the use of category
1 G apparatus is required, it must be installed such, that, even in the event of rare incidents,
ignition sources due to impact and friction sparks are excluded.
Page 2/3
Form 100
Version 1 (2010-12)
(13)
SCHEDULE
(14)
to EC-Type Examination Certificate DEKRA 11ATEX0039 X
(18)
Essential Health and Safety Requirements
Issue No. 1
Covered by the standards listed at (9).
(19)
Test documentation
As listed in Test Report NL/KEM/ExTR08.0014/**.
Page 3/3
Form 100
Version 1 (2010-12)