Pulsar IECEx ia

IECEx Certificate
of Conformity
Certificate No.:
IECEx DEK 11.0034X
Date of Issue:
2011-06-15
Issue No.: 0
Page 2 of 3
Manufacturer:
Magnetrol International N.V.
Heikensstraat 6
9240 Zele
Belgium
Manufacturing location(s):
Magnetrol International
NV
Heikensstraat 6
9240 Zele
Belgium
Magnetrol International
Inc.
5300 Belmont Road
Downers Grove, IL
60515-4499
United States of America
This certificate is issued as verification that a sample(s), representative of production, was assessed and tested and
found to comply with the IEC Standard list below and that the manufacturer's quality system, relating to the Ex products
covered by this certificate, was assessed and found to comply with the IECEx Quality system requirements. This
certificate is granted subject to the conditions as set out in IECEx Scheme Rules, IECEx 02 and Operational Documents
as amended.
STANDARDS:
The electrical apparatus and any acceptable variations to it specified in the schedule of this certificate and the identified
documents, was found to comply with the following standards:
IEC 60079-0 : 2007-10
Explosive atmospheres - Part 0:Equipment - General requirements
IEC 60079-11 : 2006
Explosive atmospheres - Part 11: Equipment protection by intrinsic safety "i"
IEC 60079-26 : 2006
Explosive atmospheres - Part 26: Equipment with equipment protection level (EPL) Ga
Edition: 5
Edition: 5
Edition: 2
This Certificate does not indicate compliance with electrical safety and performance requirements other than those
expressly included in the Standards listed above.
TEST & ASSESSMENT REPORTS:
A sample(s) of the equipment listed has successfully met the examination and test requirements as recorded in
Test Report:
NL/DEK/ExTR11.0026/00
Quality Assessment Report:
CA/CSA/QAR06.0004/06
NL/KEM/QAR08.0036/02
IECEx Certificate
of Conformity
Certificate No.:
IECEx DEK 11.0034X
Date of Issue:
2011-06-15
Issue No.: 0
Page 3 of 3
Schedule
EQUIPMENT:
Equipment and systems covered by this certificate are as follows:
The Radar Level Transmitter Model Pulsar Rx5 measures the level of the fluid using a microwave beam. The
output signal is a 4 - 20 mA current signal with digital communication (HART). The antenna is a horn or a
dielectric rod type.
The transmitter is provided with a display for local read-out and configuration.
Ambient temperature range -40 °C to +70 °C.
Electrical data
Output/supply circuit (terminals + and -):
in type of protection intrinsic safety Ex ia IIC, only for connection to a certified intrinsically safe circuit,
with the following maximum values:
Ui = 28.4 V; Ii = 120 mA; Pi = 0.84 W; Ci = 2.2 nF; Li = 430 µH.
CONDITIONS OF CERTIFICATION: YES as shown below:
Because the enclosure of the Radar Level Transmitter Model Pulsar Rx5 is made of aluminium, if it is mounted
in an area where the use of apparatus of equipment protection level Ga is required, it must be installed such,
that, even in the event of rare incidents, ignition sources due to impact and friction sparks are excluded.
The transmitter's antenna shall be installed so, that electrostatic discharges are prevented.