Specification Oscillator type: Rev.: 2 Date: 2016-02-29 AXIOM30DR High Performance Double Oven (DOCXO) Produced in association with Magic Xtal – Model MXODR Parameter Frequency range Standard frequencies Frequency stability Initial tolerance @ +25°C vs. operating temperature range vs. supply voltage variation (pushing) vs. load change (pulling) Long term (aging) per day st Long term (aging) 1 year Frequency adjustment range Electronic Frequency Control (EFC) EFC voltage VC EFC slope (∆f / ∆VC) EFC input impedance RF output (Note 2) Signal waveform Load RL Output level Harmonics Sub-harmonics Spurious Warm-up time @ +25°C (Note 3) Phase noise @ 10.000 MHz Short term stability (Allan deviation) Reference voltage VREF output Supply voltage VS (Note 4) Current consumption (steady state) Current consumption (warm-up) Enclosure (see drawing) (LxWxH) Weight Packing Notes: 1. 2. 3. 4. min. typ. 5 max. Unit 100 MHz MHz ±100 ppb VC @ VREF/2 steady state ±0.2 ±0.2 ±0.2 ±20 ppb ppb ppb ppb VS ±5 % RL ±5 % after 30 days operation after 30 days operation VREF ppm V 10.000 Option 1 & 2 See tables 1 & 2 ±0.5 0 +6 ±1.0 VREF/2 Positive 11 Sine wave 50 +8 kΩ +10 -30 -40 -70 90 -95 -125 -145 -155 -163 Ω dBm dBc dBc dBc sec dBc/Hz dBc/Hz dBc/Hz dBc/Hz dBc/Hz -12 4.1 4.75 4.2 5.0 200 Condition 3·10 4.3 5.25 240 800 20.4x20.4x13.0 max. 20 Palette V V mA mA ±5% fnom > 30 MHz only ∆ffinal/f0 < ±0.1 ppm @ 1 Hz @ 10 Hz @ 100 Hz @ 1 kHz @ 10 kHz τ=1s @ +25°C mm g Terminology and test conditions are according to IEC60679-1 and MIL-PRF-55310, unless otherwise stated HCMOS output on request Frequency referred to ffinal at 30 minutes after switch-on 3.3 V supply voltage on request GmbH & Co. KG Roemerring 9 D-74821 Mosbach Germany AXIOM30DR Rev.2 Drawing D1 Page 1(4) www.axtal.com fon: +49 (6261) 939834 fax: +49 (6261) 939836 E-mail: [email protected] Absolute Maximum Ratings Parameter min. max. Supply Voltage VS Control Voltage VC Storage Temperature -0.5 -0.5 -60 VS + 10% 5 +90 Unit Condition V V °C VS to GND VC to GND Frequency stability vs. temperature Stability [ppb] ±0.1 ±0.2 ±0.3 ±0.5 ±1 Option 1 001 002 003 005 01 Table 1 Lower Temperature Option 2 T [°C] 0 0 1 -10 2 -20 3 -30 Table 2 Upper Temperature Option 2 T [°C] A +50 B +60 C +70 Standard: “1B” = -10°C to +60°C Note: Not all combinations of stability and temperature range may be available. Please consult factory. Ordering Code Option 1 Option 2 [Stability] [Temperature range] AXIOM30DR Table 1 Table 2 Example: AXIOM30DR-002-1B_Rev.2 – 10.000 MHz Model Handling and Testing Parameter Handling and Testing Processing Parameter Electrostatic discharge (ESD) THD devices SMD devices Washable RoHS- Compliant GmbH & Co. KG Roemerring 9 D-74821 Mosbach Germany Revision Frequency [MHz] Rev.2 10.000 Procedure Application Note AXAN-011 Application Note AXAN-012 Procedure IEC60749-26 IEC60749-27 Yes Yes AXIOM30DR Rev.2 Drawing D1 Page 2(4) HBM MM No No Source www.axtal.com www.axtal.com Condition 2000 V 200 V www.axtal.com fon: +49 (6261) 939834 fax: +49 (6261) 939836 E-mail: [email protected] Enclosure drawing Pin connections: Pin # 1 2 3 4 5 Symbol VC VREF GND RF OUT VS Function Control Voltage (EFC) Reference voltage Ground RF Output Supply Voltage * See Application Note AXAN-011 Environmental conditions Test IEC 60068 Part … 2-17 IEC 60679-1 Clause 5.6.2 MIL-STD202G Method 112E 2-20 2-58 5.6.3 208H 210F 2-27 5.6.8 213B 516.4 3.6.40 Vibration, sinusoidal* 2-6 5.6.7.1 201A 204D 516.4-4 3.6.38.1 3.6.38.2 Vibration, random* Endurance tests - ageing - extended aging 2-64 5.6.7.3 214A 514.5 3.6.38.3 3.6.38.4 Sealing tests (if applicable) Solderability Resistance to soldering heat Shock* MIL-PRF55310D Clause 3.6.1.2 3.6.52 3.6.48 Test conditions (IEC) Gross leak: Test Qc, Fine leak: Test Qk Test Ta Method 1 Test Td1 Method 2 Test Td2 Method 2 Test Ea, 3 x per axes 30g, 11 ms half-sine pulse Test Fc, 30 min per axes, 10 Hz - 55 Hz 0,75mm; 55 Hz – 500 Hz, 10g Test Fdb 108A 5.7.1 5.7.2 GmbH & Co. KG Roemerring 9 D-74821 Mosbach Germany MIL-STD810F Method 4.8.35 AXIOM30DR Rev.2 Drawing D1 Page 3(4) 30 days @ 85°C, OCXO @25°C 1000h, 2000h, 8000h @85°C www.axtal.com fon: +49 (6261) 939834 fax: +49 (6261) 939836 E-mail: [email protected] Revision History Rev. Drawing Date [dd.mm.yyyy] 1 1 2 2 D0 D1 D0 D1 16.01.2015 18.09.2015 23.11.2015 29.02.2016 GmbH & Co. KG Roemerring 9 D-74821 Mosbach Germany Remarks First issue Editorial changes VC input impedance changed, shock and vibration changed Editorial changes AXIOM30DR Rev.2 Drawing D1 Page 4(4) Author Checked HH HH BN HH HH HH BN HH www.axtal.com fon: +49 (6261) 939834 fax: +49 (6261) 939836 E-mail: [email protected]