Specification for an SMD Crystal Filter MtronPTI P/N: XF9321-001 I. General & Electrical Requirements @ 25˚C 1. Center Frequency (FO): 110.2MHz 2. Passband Bandwidth: @ 1dB: FO 7.5kHz @ 3dB: FO 10.0kHz 3. Insertion Loss (@ FO): ≤ 4.5dB 4. Passband Ripple (peak-valley): ≤ 0.7dB 5. Group Delay Variation Within FO 7.5kHz: ≤ 15µsec 6. Stopband Attenuation: > 45dB: FO 45.0kHz (absolute) > 70dB: FO 910.0kHz 7. Input 3rd Order Intercept Point: > +30dBm Input Frequency: FO 50kHz, FO 100kHz Input Level: -10dBm to -20dBm 8. Input Signal Power: Working: ≤ +5dBm Peak (no damage): +15dBm 9. ZS/ZL: 50 nominal II. General & Electrical Requirements -30C to +75C 1. Center Frequency (FO): 110.2MHz 2. Passband Bandwidth: @ 1dB: FO 6.0kHz @ 3dB: FO 8.0kHz 3. Insertion Loss (@ FO): ≤ 5.0dB 4. Passband Ripple (peak-valley): ≤ 1dB 5. Group Delay Variation Within FO 7.5kHz: ≤ 17µsec 6. Stopband Attenuation: > 45dB: FO 48.0kHz (absolute) > 70dB: FO 910.0kHz 7. Input 3rd Order Intercept Point: > +30dBm Input Frequency: FO 50kHz, FO 100kHz Input Level: -10dBm to -20dBm 8. Input Signal Power: Working: ≤ +5dBm Peak (no damage): +15dBm 9. ZS/ZL: 50 nominal Rev. A 01/09/2012 Page 1 of 2 Proprietary Document Information contained herein is proprietary to MtronPTI and is submitted in confidence. Information may not be copied or divulged without written permission from MtronPTI. Specification for an SMD Crystal Filter MtronPTI P/N: XF9321-001 III. Environmental & Physical Requirements: 1. Temperature Range Operating: -30C to +75C Storage: -45C to +85C 2. Package: SMD (ref drawing Figure 2) 3. RoHS: Full RoHS Compliance Figure 1: Maximum Solder Reflow Profile Figure 2: Package Outline Drawing Rev. A 01/09/2012 Page 2 of 2 Proprietary Document Information contained herein is proprietary to MtronPTI and is submitted in confidence. Information may not be copied or divulged without written permission from MtronPTI.