281 685 rn y. t. ±2.0 x 10-7 ±2.0 x 10-7 Specifications Consult Factory -40 to +60 -40 to +60 Additional Warm-up current Current 250 mA max ±5.0 x 10-7 ±5.0 x 10-7 Clipped Sine Clipped Sine HCMOS 5 V ±5% 5 V ±5% 250 mA max 65 mA typical @ -40 °C steady state 25 mA typical @ +25 °C steady state 65 mA typical @ -40 °C steady state 25 mAXO5060 typical @ +25 °C steadySeries state 10 mA typical @ +60 °C steady state 10 mA typical @ +60 °C steady state Warm-up 60 sec @ -40 °COCXO 14 DIP, 5.0 Volt, Sinewave, 60 sec @ -40pin °C time 0.5 Control V to 5 V voltage 0.5 V to 5 V ±7.0 x 10-7 (Ref to nominal freq) Aging adjustment ±7.0 x 10-7 (Ref to nominal freq) Positive • Standard DIP Package Slope Positive ±1.0 x 10-7 Stabilities stability ±1.0Frequency x • 10-7 Tight ±5.0 xVs 10-11 supply ±1.0 x 10-7 • Fastvoltage Warm-up Vs variation ±1.0 x 10-7 • load Low Current RF out -75 Short dBc/Hz term (-tau = 1s) ±5.0 x 10-11 Osc (+) -105 dBc/Hz 14 -135 dBc/Hz -145Phase dBc/Hz -150 dBc/Hz 8 This product is 1not Noise @ 10MHz R L 1 Hz -75 dBc/Hz ± recommended for 7 new designs 10 Hz -105 dBc/Hz Osc (-) 10 k Ω//10 pF Hz -135 dBc/Hz 1.5 100 Vpp typical 1 kHz -145 dBc/Hz .815 (20.70) MAX 10 kHz -150 dBc/Hz .600 (15.24) CENT. 40/60 2 Gates .325 (8.26) MAX Sinewave Version Load Output level CL 14 8 1 .25 (6.35) TYP. 10 k Ω//10 pF 8 1.5 Vpp typical Osc (-) 14 .18 (4.60) CENT. .03 (.76) TYP. .018 (.45) DIA TYP. .815 (20.70) MAX .300 (7.62) CENT. 40/60 2 Gates 7 .325 (8.26) MAX .600 (15.24) CENT. .48 (12.19) CENT. 1 .060 (1.52) DIA STANDOFF, TYP. .25 (6.35) TYP. C L 8 Specifications are subject to change without notice. Dimensions are in inches (mm) sit our web site at http: //www.piezotech.com 25 Shader Road, 32804 PH: (407) 298-2000 / FAX: (407) 293-2979 8 PinFLconnections Frequency adjust Case ground & supply return R.F. Output Supply (+) ± 7 C L C L CL R L .48 (12.19) CENT. .515 (13.08) Version HCMOS MAX Duty cycle Load 1. 7. 8. 14. RF out Osc (+) .515 (13.08) MAX 14 .18 (4.60) CENT. C L Pin numbers shown for ref. only. Numbers are not marked on unit. .300 (7.62) CENT. 7 .03 (.76) TYP. .018 (.45) DIA TYP. 1 .060 (1.52) DIA STANDOFF, TYP. Specifications are subject to change without notice. Visit our web site at http: //www.piezotech.com 2525 Shader Road, FL 32804 PH: (407) 298-2000 / FAX: (407) 293-2979 8 MtronPTI reserves the right to make changes to the product(s) and service(s) described herein without notice. No liability is assumed as a result of their use or application. Please see www.mtronpti.com for our complete offering and detailed datasheets. Contact us for your application specific requirements: MtronPTI 1-800-762-8800. Revision: 7-9-12 MtronPTI Lead Free Solder Profile MtronPTI reserves the right to make changes to the product(s) and service(s) described herein without notice. No liability is assumed as a result of their use or application. Please see www.mtronpti.com for our complete offering and detailed datasheets. Contact us for your application specific requirements: MtronPTI 1-800-762-8800.