Package Information www.vishay.com Vishay Siliconix QFN32 5 x 5 Case Outline D2 A D Pin 1 location indentifier (5) B 32 31 30 29 28 27 26 25 K Pin 1 location indentifier (5) 25 26 27 28 29 30 31 32 0.1 C L 1 24 24 1 2 23 23 2 3 22 22 3 4 21 21 4 5 20 20 5 E 6 19 19 6 7 18 18 7 8 17 17 8 9 10 11 12 13 14 15 16 Terminal Tip (4) 0.1 C 16 15 14 13 12 11 10 e 9 E2 b 0.1 M C A B Bottom view Top view 0.1 C C A 0.1 C Seating plane Side view DIM. A1 A3 MILLIMETERS INCHES MIN. NOM. MAX. MIN. NOM. MAX. A 0.75 0.85 0.95 0.029 0.033 0.037 A1 0.00 - 0.05 0.000 - 0.002 0.30 0.007 A3 b 0.20 ref. 0.18 D D2 0.25 0.008 ref. 5.00 BSC 3.00 3.10 0.010 0.012 0.197 BSC 3.20 0.118 0.122 e 0.50 BSC 0.020 BSC E 5.00 BSC 0.197 BSC 0.126 E2 3.00 3.10 3.20 0.118 0.122 0.126 K 0.20 - - 0.008 - - L 0.30 0.40 0.50 0.012 0.016 0.020 N (3) 32 32 Nd (3) 8 8 Ne (3) 8 8 Notes (1) Use millimeters as the primary measurement (2) Dimensioning and tolerances conform to ASME Y14.5M. - 1994 (3) N is the number of terminals, Nd is the number of terminals in X-direction and Ne is the number of terminals in Y-direction. (4) Dimension b applies to plated terminal and is measured between 0.15 mm and 0.30 mm from terminal tip (5) The pin #1 identifier must be existed on the top surface of the package by using indentation mark or other feature of package body (6) Package warpage max. 0.05 mm S14-2079-Rev. A, 20-Oct-14 DWG: 6027 Document Number: 67244 1 For technical questions, contact: [email protected] THIS DOCUMENT IS SUBJECT TO CHANGE WITHOUT NOTICE. THE PRODUCTS DESCRIBED HEREIN AND THIS DOCUMENT ARE SUBJECT TO SPECIFIC DISCLAIMERS, SET FORTH AT www.vishay.com/doc?91000 Revision: 20-Oct-14